@@ -31,7 +31,8 @@
<&gpio39_default_mode>,
<&gpio42_default_mode>,
<&gpio26_default_mode>,
- <&gpio35_default_mode>;
+ <&gpio35_default_mode>,
+ <&ycbcr_default_mode>;
/*
* Pins 2, 4, 10, 11, 12, 13, 16, 24, 25, 36, 37, 38, 39 and 42
@@ -246,6 +247,26 @@
};
};
};
+ /*
+ * This sets up the YCBCR connector pins, i.e. analog video out.
+ * Set as input with no bias.
+ */
+ ycbcr {
+ ycbcr_default_mode: ycbcr_default {
+ default_mux {
+ ste,function = "ycbcr";
+ ste,pins = "ycbcr0123_d_1";
+ };
+ default_cfg {
+ ste,pins = "GPIO6_Y18",
+ "GPIO7_AA20",
+ "GPIO8_W18",
+ "GPIO9_AA19";
+ input-enable;
+ bias-disable;
+ };
+ };
+ };
};
};
};
@@ -57,16 +57,6 @@ static struct pinctrl_map __initdata ab8500_pinmap[] = {
AB8500_PIN_STATE("GPIO3_U9", in_pd, "regulator.36", PINCTRL_STATE_SLEEP),
/*
- * pins 6,7,8 and 9 are muxed in YCBCR0123
- * configured in INPUT PULL UP
- */
- AB8500_MUX_HOG("ycbcr0123_d_1", "ycbcr"),
- AB8500_PIN_HOG("GPIO6_Y18", in_nopull),
- AB8500_PIN_HOG("GPIO7_AA20", in_nopull),
- AB8500_PIN_HOG("GPIO8_W18", in_nopull),
- AB8500_PIN_HOG("GPIO9_AA19", in_nopull),
-
- /*
* pins 14,15 are muxed in PWM1 and PWM2
* configured in INPUT PULL DOWN
*/
This moves the pin control settings for the YCBCR connector on the AB8500 over to the device tree as a hog. Cc: Patrice Chotard <patrice.chotard@st.com> Cc: Lee Jones <lee.jones@linaro.org> Signed-off-by: Linus Walleij <linus.walleij@linaro.org> --- arch/arm/boot/dts/ste-href-ab8500.dtsi | 23 ++++++++++++++++++++++- arch/arm/mach-ux500/board-mop500-pins.c | 10 ---------- 2 files changed, 22 insertions(+), 11 deletions(-)