@@ -162,6 +162,9 @@ bool spi_mem_default_supports_op(struct spi_slave *slave,
if (op->cmd.dtr || op->addr.dtr || op->dummy.dtr || op->data.dtr)
return false;
+ if (op->cmd.nbytes != 1)
+ return false;
+
return true;
}
EXPORT_SYMBOL_GPL(spi_mem_default_supports_op);
@@ -20,6 +20,7 @@
{ \
.buswidth = __buswidth, \
.opcode = __opcode, \
+ .nbytes = 1, \
}
#define SPI_MEM_OP_ADDR(__nbytes, __val, __buswidth) \
@@ -72,6 +73,8 @@ enum spi_mem_data_dir {
/**
* struct spi_mem_op - describes a SPI memory operation
+ * @cmd.nbytes: number of opcode bytes (only 1 or 2 are valid). The opcode is
+ * sent MSB-first.
* @cmd.buswidth: number of IO lines used to transmit the command
* @cmd.opcode: operation opcode
* @cmd.dtr: whether the command opcode should be sent in DTR mode or not
@@ -95,9 +98,10 @@ enum spi_mem_data_dir {
*/
struct spi_mem_op {
struct {
+ u8 nbytes;
u8 buswidth;
- u8 opcode;
u8 dtr : 1;
+ u16 opcode;
} cmd;
struct {
In xSPI mode, flashes expect 2-byte opcodes. The second byte is called the "command extension". There can be 3 types of extensions in xSPI: repeat, invert, and hex. When the extension type is "repeat", the same opcode is sent twice. When it is "invert", the second byte is the inverse of the opcode. When it is "hex" an additional opcode byte based is sent with the command whose value can be anything. So, make opcode a 16-bit value and add a 'nbytes', similar to how multiple address widths are handled. Signed-off-by: Pratyush Yadav <p.yadav at ti.com> --- drivers/spi/spi-mem.c | 3 +++ include/spi-mem.h | 6 +++++- 2 files changed, 8 insertions(+), 1 deletion(-)