diff mbox series

[v3,1/2] wcn36xx: Add VHT rates to wcn36xx_update_allowed_rates()

Message ID 20200908182542.2870535-2-pure.logic@nexus-software.ie
State New
Headers show
Series wcn36xx: Enable VHT when supported | expand

Commit Message

Bryan O'Donoghue Sept. 8, 2020, 6:25 p.m. UTC
From: Bryan O'Donoghue <bryan.odonoghue@linaro.org>


This commit adds VHT rates to the wcn36xx_update_allowed_rates() routine.
Thus allowing the driver to latch the declared rates and transmit them to
the firmware in the same way as other 80211.n rates are.

Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@linaro.org>

---
 drivers/net/wireless/ath/wcn36xx/main.c | 8 ++++++++
 1 file changed, 8 insertions(+)

-- 
2.27.0


_______________________________________________
wcn36xx mailing list
wcn36xx@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/wcn36xx
diff mbox series

Patch

diff --git a/drivers/net/wireless/ath/wcn36xx/main.c b/drivers/net/wireless/ath/wcn36xx/main.c
index 2c2b6178c8cd..9c283c110e07 100644
--- a/drivers/net/wireless/ath/wcn36xx/main.c
+++ b/drivers/net/wireless/ath/wcn36xx/main.c
@@ -766,6 +766,14 @@  static void wcn36xx_update_allowed_rates(struct ieee80211_sta *sta,
 		       sta->ht_cap.mcs.rx_mask,
 		       sizeof(sta->ht_cap.mcs.rx_mask));
 	}
+
+	if (sta->vht_cap.vht_supported) {
+		sta_priv->supported_rates.op_rate_mode = STA_11ac;
+		sta_priv->supported_rates.vht_rx_mcs_map =
+				sta->vht_cap.vht_mcs.rx_mcs_map;
+		sta_priv->supported_rates.vht_tx_mcs_map =
+				sta->vht_cap.vht_mcs.tx_mcs_map;
+	}
 }
 void wcn36xx_set_default_rates(struct wcn36xx_hal_supported_rates *rates)
 {