@@ -561,6 +561,7 @@ static void floppy_release_irq_and_dma(void);
* output_byte is automatically disabled when reset is set.
*/
static void reset_fdc(void);
+static int floppy_revalidate(struct gendisk *disk);
/*
* These are global variables, as that's the easiest way to give
@@ -3275,7 +3276,8 @@ static int invalidate_drive(struct block_device *bdev)
/* invalidate the buffer track to force a reread */
set_bit((long)bdev->bd_disk->private_data, &fake_change);
process_fd_request();
- check_disk_change(bdev);
+ if (bdev_check_media_change(bdev))
+ floppy_revalidate(bdev->bd_disk);
return 0;
}
@@ -4123,7 +4125,8 @@ static int floppy_open(struct block_device *bdev, fmode_t mode)
drive_state[drive].last_checked = 0;
clear_bit(FD_OPEN_SHOULD_FAIL_BIT,
&drive_state[drive].flags);
- check_disk_change(bdev);
+ if (bdev_check_media_change(bdev))
+ floppy_revalidate(bdev->bd_disk);
if (test_bit(FD_DISK_CHANGED_BIT, &drive_state[drive].flags))
goto out;
if (test_bit(FD_OPEN_SHOULD_FAIL_BIT, &drive_state[drive].flags))
@@ -4291,7 +4294,6 @@ static const struct block_device_operations floppy_fops = {
.ioctl = fd_ioctl,
.getgeo = fd_getgeo,
.check_events = floppy_check_events,
- .revalidate_disk = floppy_revalidate,
#ifdef CONFIG_COMPAT
.compat_ioctl = fd_compat_ioctl,
#endif
Switch to use bdev_check_media_change instead of check_disk_change and call floppy_revalidate manually. Given that floppy_revalidate only deals with media change events, the extra call into ->revalidate_disk from bdev_disk_changed is not required either, so stop wiring up the method. Signed-off-by: Christoph Hellwig <hch@lst.de> --- drivers/block/floppy.c | 8 +++++--- 1 file changed, 5 insertions(+), 3 deletions(-)