@@ -740,15 +740,6 @@ static void xhci_hub_report_usb3_link_state(struct xhci_hcd *xhci,
{
u32 pls = status_reg & PORT_PLS_MASK;
- /* resume state is a xHCI internal state.
- * Do not report it to usb core, instead, pretend to be U3,
- * thus usb core knows it's not ready for transfer
- */
- if (pls == XDEV_RESUME) {
- *status |= USB_SS_PORT_LS_U3;
- return;
- }
-
/* When the CAS bit is set then warm reset
* should be performed on port
*/
@@ -770,6 +761,16 @@ static void xhci_hub_report_usb3_link_state(struct xhci_hcd *xhci,
*/
pls |= USB_PORT_STAT_CONNECTION;
} else {
+ /*
+ * Resume state is an xHCI internal state. Do not report it to
+ * usb core, instead, pretend to be U3, thus usb core knows
+ * it's not ready for transfer.
+ */
+ if (pls == XDEV_RESUME) {
+ *status |= USB_SS_PORT_LS_U3;
+ return;
+ }
+
/*
* If CAS bit isn't set but the Port is already at
* Compliance Mode, fake a connection so the USB core
Sometimes re-plugging a USB device during system sleep renders the device useless: [ 173.418345] xhci_hcd 0000:00:14.0: Get port status 2-4 read: 0x14203e2, return 0x10262 ... [ 176.496485] usb 2-4: Waited 2000ms for CONNECT [ 176.496781] usb usb2-port4: status 0000.0262 after resume, -19 [ 176.497103] usb 2-4: can't resume, status -19 [ 176.497438] usb usb2-port4: logical disconnect Because PLS equals to XDEV_RESUME, xHCI driver reports U3 to usbcore, despite of CAS bit is flagged. So proritize CAS over XDEV_RESUME to let usbcore handle warm-reset for the port. Signed-off-by: Kai-Heng Feng <kai.heng.feng@canonical.com> --- drivers/usb/host/xhci-hub.c | 19 ++++++++++--------- 1 file changed, 10 insertions(+), 9 deletions(-)