@@ -1291,7 +1291,7 @@ static void rt2400pci_txdone(struct rt2x00_dev *rt2x00dev,
break;
case 2: /* Failure, excessive retries */
__set_bit(TXDONE_EXCESSIVE_RETRY, &txdesc.flags);
- /* Fall through - this is a failed frame! */
+ fallthrough; /* this is a failed frame! */
default: /* Failure */
__set_bit(TXDONE_FAILURE, &txdesc.flags);
}
@@ -1419,7 +1419,7 @@ static void rt2500pci_txdone(struct rt2x00_dev *rt2x00dev,
break;
case 2: /* Failure, excessive retries */
__set_bit(TXDONE_EXCESSIVE_RETRY, &txdesc.flags);
- /* Fall through - this is a failed frame! */
+ fallthrough; /* this is a failed frame! */
default: /* Failure */
__set_bit(TXDONE_FAILURE, &txdesc.flags);
}
@@ -928,7 +928,7 @@ static void rt2800_rate_from_status(struct skb_frame_desc *skbdesc,
switch (rt2x00_get_field32(status, TX_STA_FIFO_PHYMODE)) {
case RATE_MODE_HT_GREENFIELD:
flags |= IEEE80211_TX_RC_GREEN_FIELD;
- /* fall through */
+ fallthrough;
case RATE_MODE_HT_MIX:
flags |= IEEE80211_TX_RC_MCS;
break;
@@ -2567,7 +2567,7 @@ static void rt2800_config_channel_rf3052(struct rt2x00_dev *rt2x00dev,
switch (rt2x00dev->default_ant.tx_chain_num) {
case 1:
rt2x00_set_field8(&rfcsr, RFCSR1_TX1_PD, 1);
- /* fall through */
+ fallthrough;
case 2:
rt2x00_set_field8(&rfcsr, RFCSR1_TX2_PD, 1);
break;
@@ -2576,7 +2576,7 @@ static void rt2800_config_channel_rf3052(struct rt2x00_dev *rt2x00dev,
switch (rt2x00dev->default_ant.rx_chain_num) {
case 1:
rt2x00_set_field8(&rfcsr, RFCSR1_RX1_PD, 1);
- /* fall through */
+ fallthrough;
case 2:
rt2x00_set_field8(&rfcsr, RFCSR1_RX2_PD, 1);
break;
@@ -2768,10 +2768,10 @@ static void rt2800_config_channel_rf3053(struct rt2x00_dev *rt2x00dev,
switch (rt2x00dev->default_ant.tx_chain_num) {
case 3:
rt2x00_set_field8(&rfcsr, RFCSR1_TX2_PD, 1);
- /* fallthrough */
+ fallthrough;
case 2:
rt2x00_set_field8(&rfcsr, RFCSR1_TX1_PD, 1);
- /* fallthrough */
+ fallthrough;
case 1:
rt2x00_set_field8(&rfcsr, RFCSR1_TX0_PD, 1);
break;
@@ -2780,10 +2780,10 @@ static void rt2800_config_channel_rf3053(struct rt2x00_dev *rt2x00dev,
switch (rt2x00dev->default_ant.rx_chain_num) {
case 3:
rt2x00_set_field8(&rfcsr, RFCSR1_RX2_PD, 1);
- /* fallthrough */
+ fallthrough;
case 2:
rt2x00_set_field8(&rfcsr, RFCSR1_RX1_PD, 1);
- /* fallthrough */
+ fallthrough;
case 1:
rt2x00_set_field8(&rfcsr, RFCSR1_RX0_PD, 1);
break;
@@ -3005,10 +3005,10 @@ static void rt2800_config_channel_rf3853(struct rt2x00_dev *rt2x00dev,
switch (rt2x00dev->default_ant.tx_chain_num) {
case 3:
rt2x00_set_field8(&rfcsr, RFCSR1_TX2_PD, 1);
- /* fallthrough */
+ fallthrough;
case 2:
rt2x00_set_field8(&rfcsr, RFCSR1_TX1_PD, 1);
- /* fallthrough */
+ fallthrough;
case 1:
rt2x00_set_field8(&rfcsr, RFCSR1_TX0_PD, 1);
break;
@@ -3017,10 +3017,10 @@ static void rt2800_config_channel_rf3853(struct rt2x00_dev *rt2x00dev,
switch (rt2x00dev->default_ant.rx_chain_num) {
case 3:
rt2x00_set_field8(&rfcsr, RFCSR1_RX2_PD, 1);
- /* fallthrough */
+ fallthrough;
case 2:
rt2x00_set_field8(&rfcsr, RFCSR1_RX1_PD, 1);
- /* fallthrough */
+ fallthrough;
case 1:
rt2x00_set_field8(&rfcsr, RFCSR1_RX0_PD, 1);
break;
@@ -4216,14 +4216,14 @@ static void rt2800_config_channel(struct rt2x00_dev *rt2x00dev,
rf->channel > 14);
rt2x00_set_field32(&tx_pin, TX_PIN_CFG_PA_PE_G2_EN,
rf->channel <= 14);
- /* fall-through */
+ fallthrough;
case 2:
/* Turn on secondary PAs */
rt2x00_set_field32(&tx_pin, TX_PIN_CFG_PA_PE_A1_EN,
rf->channel > 14);
rt2x00_set_field32(&tx_pin, TX_PIN_CFG_PA_PE_G1_EN,
rf->channel <= 14);
- /* fall-through */
+ fallthrough;
case 1:
/* Turn on primary PAs */
rt2x00_set_field32(&tx_pin, TX_PIN_CFG_PA_PE_A0_EN,
@@ -4241,12 +4241,12 @@ static void rt2800_config_channel(struct rt2x00_dev *rt2x00dev,
/* Turn on tertiary LNAs */
rt2x00_set_field32(&tx_pin, TX_PIN_CFG_LNA_PE_A2_EN, 1);
rt2x00_set_field32(&tx_pin, TX_PIN_CFG_LNA_PE_G2_EN, 1);
- /* fall-through */
+ fallthrough;
case 2:
/* Turn on secondary LNAs */
rt2x00_set_field32(&tx_pin, TX_PIN_CFG_LNA_PE_A1_EN, 1);
rt2x00_set_field32(&tx_pin, TX_PIN_CFG_LNA_PE_G1_EN, 1);
- /* fall-through */
+ fallthrough;
case 1:
/* Turn on primary LNAs */
rt2x00_set_field32(&tx_pin, TX_PIN_CFG_LNA_PE_A0_EN, 1);
@@ -5438,10 +5438,10 @@ void rt2800_vco_calibration(struct rt2x00_dev *rt2x00dev)
switch (rt2x00dev->default_ant.tx_chain_num) {
case 3:
rt2x00_set_field32(&tx_pin, TX_PIN_CFG_PA_PE_G2_EN, 1);
- /* fall through */
+ fallthrough;
case 2:
rt2x00_set_field32(&tx_pin, TX_PIN_CFG_PA_PE_G1_EN, 1);
- /* fall through */
+ fallthrough;
case 1:
default:
rt2x00_set_field32(&tx_pin, TX_PIN_CFG_PA_PE_G0_EN, 1);
@@ -5451,10 +5451,10 @@ void rt2800_vco_calibration(struct rt2x00_dev *rt2x00dev)
switch (rt2x00dev->default_ant.tx_chain_num) {
case 3:
rt2x00_set_field32(&tx_pin, TX_PIN_CFG_PA_PE_A2_EN, 1);
- /* fall through */
+ fallthrough;
case 2:
rt2x00_set_field32(&tx_pin, TX_PIN_CFG_PA_PE_A1_EN, 1);
- /* fall through */
+ fallthrough;
case 1:
default:
rt2x00_set_field32(&tx_pin, TX_PIN_CFG_PA_PE_A0_EN, 1);
@@ -10100,10 +10100,10 @@ static int rt2800_probe_hw_mode(struct rt2x00_dev *rt2x00dev)
switch (rx_chains) {
case 3:
spec->ht.mcs.rx_mask[2] = 0xff;
- /* fall through */
+ fallthrough;
case 2:
spec->ht.mcs.rx_mask[1] = 0xff;
- /* fall through */
+ fallthrough;
case 1:
spec->ht.mcs.rx_mask[0] = 0xff;
spec->ht.mcs.rx_mask[4] = 0x1; /* MCS32 */
@@ -593,7 +593,6 @@ void rt2800mmio_queue_init(struct data_queue *queue)
break;
case QID_ATIM:
- /* fallthrough */
default:
BUG();
break;
@@ -746,7 +746,6 @@ static void rt2800usb_queue_init(struct data_queue *queue)
break;
case QID_ATIM:
- /* fallthrough */
default:
BUG();
break;
@@ -2130,7 +2130,7 @@ static void rt61pci_txdone(struct rt2x00_dev *rt2x00dev)
break;
case 6: /* Failure, excessive retries */
__set_bit(TXDONE_EXCESSIVE_RETRY, &txdesc.flags);
- /* Fall through - this is a failed frame! */
+ fallthrough; /* this is a failed frame! */
default: /* Failure */
__set_bit(TXDONE_FAILURE, &txdesc.flags);
}
@@ -2953,7 +2953,6 @@ static void rt61pci_queue_init(struct data_queue *queue)
break;
case QID_ATIM:
- /* fallthrough */
default:
BUG();
break;
@@ -2373,7 +2373,6 @@ static void rt73usb_queue_init(struct data_queue *queue)
break;
case QID_ATIM:
- /* fallthrough */
default:
BUG();
break;
Replace the existing /* fall through */ comments and its variants with the new pseudo-keyword macro fallthrough[1]. Also, remove unnecessary fall-through markings when it is the case. [1] https://www.kernel.org/doc/html/v5.7/process/deprecated.html?highlight=fallthrough#implicit-switch-case-fall-through Signed-off-by: Gustavo A. R. Silva <gustavoars@kernel.org> --- .../net/wireless/ralink/rt2x00/rt2400pci.c | 2 +- .../net/wireless/ralink/rt2x00/rt2500pci.c | 2 +- .../net/wireless/ralink/rt2x00/rt2800lib.c | 42 +++++++++---------- .../net/wireless/ralink/rt2x00/rt2800mmio.c | 1 - .../net/wireless/ralink/rt2x00/rt2800usb.c | 1 - drivers/net/wireless/ralink/rt2x00/rt61pci.c | 3 +- drivers/net/wireless/ralink/rt2x00/rt73usb.c | 1 - 7 files changed, 24 insertions(+), 28 deletions(-)