diff mbox series

[RESEND] net: dsa: microchip: look for phy-mode in port nodes

Message ID 20200820060331.GA23489@laureti-dev
State New
Headers show
Series [RESEND] net: dsa: microchip: look for phy-mode in port nodes | expand

Commit Message

Helmut Grohne Aug. 20, 2020, 6:03 a.m. UTC
Documentation/devicetree/bindings/net/dsa/dsa.txt says that the phy-mode
property should be specified on port nodes. However, the microchip
drivers read it from the switch node.

Let the driver use the per-port property and fall back to the old
location with a warning.

Fix in-tree users.

Signed-off-by: Helmut Grohne <helmut.grohne@intenta.de>
Link: https://lore.kernel.org/netdev/20200617082235.GA1523@laureti-dev/
---
 arch/arm/boot/dts/at91-sama5d2_icp.dts |  2 +-
 drivers/net/dsa/microchip/ksz8795.c    | 17 +++++++++++-----
 drivers/net/dsa/microchip/ksz9477.c    | 28 +++++++++++++++++---------
 drivers/net/dsa/microchip/ksz_common.c | 13 +++++++++++-
 drivers/net/dsa/microchip/ksz_common.h |  3 ++-
 5 files changed, 45 insertions(+), 18 deletions(-)

Why resend?

Andrew Lunn agreed to the semantic change performed in the patch, but
not to the implementation. He asked for a simpler implementation. I
attempted doing that, but it ultimately failed, because the knowledge of
which port is the cpu port is not available at the time of parsing the
device tree. I've documented my attempts and alternatives at
https://lore.kernel.org/netdev/20200716100743.GA3275@laureti-dev/ and
reached the conclusion that my initial implementation is the simplest
option. Please reconsider including it.

Helmut
diff mbox series

Patch

diff --git a/arch/arm/boot/dts/at91-sama5d2_icp.dts b/arch/arm/boot/dts/at91-sama5d2_icp.dts
index 8d19925fc09e..6783cf16ff81 100644
--- a/arch/arm/boot/dts/at91-sama5d2_icp.dts
+++ b/arch/arm/boot/dts/at91-sama5d2_icp.dts
@@ -116,7 +116,6 @@ 
 		switch0: ksz8563@0 {
 			compatible = "microchip,ksz8563";
 			reg = <0>;
-			phy-mode = "mii";
 			reset-gpios = <&pioA PIN_PD4 GPIO_ACTIVE_LOW>;
 
 			spi-max-frequency = <500000>;
@@ -140,6 +139,7 @@ 
 					reg = <2>;
 					label = "cpu";
 					ethernet = <&macb0>;
+					phy-mode = "mii";
 					fixed-link {
 						speed = <100>;
 						full-duplex;
diff --git a/drivers/net/dsa/microchip/ksz8795.c b/drivers/net/dsa/microchip/ksz8795.c
index 8f1d15ea15d9..cae77eafd533 100644
--- a/drivers/net/dsa/microchip/ksz8795.c
+++ b/drivers/net/dsa/microchip/ksz8795.c
@@ -932,11 +932,18 @@  static void ksz8795_port_setup(struct ksz_device *dev, int port, bool cpu_port)
 	ksz_port_cfg(dev, port, P_PRIO_CTRL, PORT_802_1P_ENABLE, true);
 
 	if (cpu_port) {
+		if (!p->interface && dev->compat_interface) {
+			dev_warn(dev->dev,
+				 "Using legacy switch \"phy-mode\" missing on port %d node. Please update your device tree.\n",
+				 port);
+			p->interface = dev->compat_interface;
+		}
+
 		/* Configure MII interface for proper network communication. */
 		ksz_read8(dev, REG_PORT_5_CTRL_6, &data8);
 		data8 &= ~PORT_INTERFACE_TYPE;
 		data8 &= ~PORT_GMII_1GPS_MODE;
-		switch (dev->interface) {
+		switch (p->interface) {
 		case PHY_INTERFACE_MODE_MII:
 			p->phydev.speed = SPEED_100;
 			break;
@@ -952,11 +959,11 @@  static void ksz8795_port_setup(struct ksz_device *dev, int port, bool cpu_port)
 		default:
 			data8 &= ~PORT_RGMII_ID_IN_ENABLE;
 			data8 &= ~PORT_RGMII_ID_OUT_ENABLE;
-			if (dev->interface == PHY_INTERFACE_MODE_RGMII_ID ||
-			    dev->interface == PHY_INTERFACE_MODE_RGMII_RXID)
+			if (p->interface == PHY_INTERFACE_MODE_RGMII_ID ||
+			    p->interface == PHY_INTERFACE_MODE_RGMII_RXID)
 				data8 |= PORT_RGMII_ID_IN_ENABLE;
-			if (dev->interface == PHY_INTERFACE_MODE_RGMII_ID ||
-			    dev->interface == PHY_INTERFACE_MODE_RGMII_TXID)
+			if (p->interface == PHY_INTERFACE_MODE_RGMII_ID ||
+			    p->interface == PHY_INTERFACE_MODE_RGMII_TXID)
 				data8 |= PORT_RGMII_ID_OUT_ENABLE;
 			data8 |= PORT_GMII_1GPS_MODE;
 			data8 |= PORT_INTERFACE_RGMII;
diff --git a/drivers/net/dsa/microchip/ksz9477.c b/drivers/net/dsa/microchip/ksz9477.c
index dc999406ce86..32150c76d8f7 100644
--- a/drivers/net/dsa/microchip/ksz9477.c
+++ b/drivers/net/dsa/microchip/ksz9477.c
@@ -1208,7 +1208,7 @@  static void ksz9477_port_setup(struct ksz_device *dev, int port, bool cpu_port)
 
 		/* configure MAC to 1G & RGMII mode */
 		ksz_pread8(dev, port, REG_PORT_XMII_CTRL_1, &data8);
-		switch (dev->interface) {
+		switch (p->interface) {
 		case PHY_INTERFACE_MODE_MII:
 			ksz9477_set_xmii(dev, 0, &data8);
 			ksz9477_set_gbit(dev, false, &data8);
@@ -1229,11 +1229,11 @@  static void ksz9477_port_setup(struct ksz_device *dev, int port, bool cpu_port)
 			ksz9477_set_gbit(dev, true, &data8);
 			data8 &= ~PORT_RGMII_ID_IG_ENABLE;
 			data8 &= ~PORT_RGMII_ID_EG_ENABLE;
-			if (dev->interface == PHY_INTERFACE_MODE_RGMII_ID ||
-			    dev->interface == PHY_INTERFACE_MODE_RGMII_RXID)
+			if (p->interface == PHY_INTERFACE_MODE_RGMII_ID ||
+			    p->interface == PHY_INTERFACE_MODE_RGMII_RXID)
 				data8 |= PORT_RGMII_ID_IG_ENABLE;
-			if (dev->interface == PHY_INTERFACE_MODE_RGMII_ID ||
-			    dev->interface == PHY_INTERFACE_MODE_RGMII_TXID)
+			if (p->interface == PHY_INTERFACE_MODE_RGMII_ID ||
+			    p->interface == PHY_INTERFACE_MODE_RGMII_TXID)
 				data8 |= PORT_RGMII_ID_EG_ENABLE;
 			p->phydev.speed = SPEED_1000;
 			break;
@@ -1269,23 +1269,31 @@  static void ksz9477_config_cpu_port(struct dsa_switch *ds)
 			dev->cpu_port = i;
 			dev->host_mask = (1 << dev->cpu_port);
 			dev->port_mask |= dev->host_mask;
+			p = &dev->ports[i];
 
 			/* Read from XMII register to determine host port
 			 * interface.  If set specifically in device tree
 			 * note the difference to help debugging.
 			 */
 			interface = ksz9477_get_interface(dev, i);
-			if (!dev->interface)
-				dev->interface = interface;
-			if (interface && interface != dev->interface)
+			if (!p->interface) {
+				if (dev->compat_interface) {
+					dev_warn(dev->dev,
+						 "Using legacy switch \"phy-mode\" missing on port %d node. Please update your device tree.\n",
+						 i);
+					p->interface = dev->compat_interface;
+				} else {
+					p->interface = interface;
+				}
+			}
+			if (interface && interface != p->interface)
 				dev_info(dev->dev,
 					 "use %s instead of %s\n",
-					  phy_modes(dev->interface),
+					  phy_modes(p->interface),
 					  phy_modes(interface));
 
 			/* enable cpu port */
 			ksz9477_port_setup(dev, i, true);
-			p = &dev->ports[dev->cpu_port];
 			p->vid_member = dev->port_mask;
 			p->on = 1;
 		}
diff --git a/drivers/net/dsa/microchip/ksz_common.c b/drivers/net/dsa/microchip/ksz_common.c
index 8d53b12d40a8..d96b7ab6bb15 100644
--- a/drivers/net/dsa/microchip/ksz_common.c
+++ b/drivers/net/dsa/microchip/ksz_common.c
@@ -389,6 +389,8 @@  int ksz_switch_register(struct ksz_device *dev,
 {
 	phy_interface_t interface;
 	int ret;
+	struct device_node *port;
+	unsigned int port_num;
 
 	if (dev->pdata)
 		dev->chip_id = dev->pdata->chip_id;
@@ -421,10 +423,19 @@  int ksz_switch_register(struct ksz_device *dev,
 	/* Host port interface will be self detected, or specifically set in
 	 * device tree.
 	 */
+	for (port_num = 0; port_num < dev->port_cnt; ++port_num)
+		dev->ports[port_num].interface = PHY_INTERFACE_MODE_NA;
 	if (dev->dev->of_node) {
 		ret = of_get_phy_mode(dev->dev->of_node, &interface);
 		if (ret == 0)
-			dev->interface = interface;
+			dev->compat_interface = interface;
+		for_each_available_child_of_node(dev->dev->of_node, port) {
+			if (of_property_read_u32(port, "reg", &port_num))
+				continue;
+			if (port_num >= dev->port_cnt)
+				return -EINVAL;
+			of_get_phy_mode(port, &dev->ports[port_num].interface);
+		}
 		dev->synclko_125 = of_property_read_bool(dev->dev->of_node,
 							 "microchip,synclko-125");
 	}
diff --git a/drivers/net/dsa/microchip/ksz_common.h b/drivers/net/dsa/microchip/ksz_common.h
index 206838160f49..cf866e48ff66 100644
--- a/drivers/net/dsa/microchip/ksz_common.h
+++ b/drivers/net/dsa/microchip/ksz_common.h
@@ -39,6 +39,7 @@  struct ksz_port {
 	u32 freeze:1;			/* MIB counter freeze is enabled */
 
 	struct ksz_port_mib mib;
+	phy_interface_t interface;
 };
 
 struct ksz_device {
@@ -72,7 +73,7 @@  struct ksz_device {
 	int mib_cnt;
 	int mib_port_cnt;
 	int last_port;			/* ports after that not used */
-	phy_interface_t interface;
+	phy_interface_t compat_interface;
 	u32 regs_size;
 	bool phy_errata_9477;
 	bool synclko_125;