diff mbox

[RESEND,v5,4/5] arm: Seperate DEBUG_UART_PHYS from DEBUG_LL on EP93XX

Message ID 1400857819-7975-5-git-send-email-daniel.thompson@linaro.org
State New
Headers show

Commit Message

Daniel Thompson May 23, 2014, 3:10 p.m. UTC
On EP93XX uncompress.h uses CONFIG_DEBUG_UART_PHYS instead of a hard
coded serial port. This means the build breaks when DEBUG_LL
(and DEBUG_LL_UART_PL01X) is not enabled.

This is fixed by adding a new dependancy.

Signed-off-by: Daniel Thompson <daniel.thompson@linaro.org>
---
 arch/arm/Kconfig.debug | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)
diff mbox

Patch

diff --git a/arch/arm/Kconfig.debug b/arch/arm/Kconfig.debug
index 4c8d7db..468cb3b 100644
--- a/arch/arm/Kconfig.debug
+++ b/arch/arm/Kconfig.debug
@@ -1069,7 +1069,8 @@  config DEBUG_UART_PHYS
 	default 0xfffff700 if ARCH_IOP33X
 	depends on DEBUG_LL_UART_8250 || DEBUG_LL_UART_PL01X || \
 		DEBUG_LL_UART_EFM32 || \
-		DEBUG_UART_8250 || DEBUG_UART_PL01X
+		DEBUG_UART_8250 || DEBUG_UART_PL01X || \
+		ARCH_EP93XX
 
 config DEBUG_UART_VIRT
 	hex "Virtual base address of debug UART"