@@ -25,5 +25,6 @@ ACPI Support
acpi-lid
lpit
video_extension
+ non-d0-probe
extcon-intel-int3496
intel-pmc-mux
new file mode 100644
@@ -0,0 +1,78 @@
+.. SPDX-License-Identifier: GPL-2.0
+
+========================================
+Probing devices in other D states than 0
+========================================
+
+Introduction
+============
+
+In some cases it may be preferred to leave certain devices powered off for the
+entire system bootup if powering on these devices has adverse side effects,
+beyond just powering on the said device.
+
+How it works
+============
+
+The _DSE (Device State for Enumeration) object that evaluates to an integer may
+be used to tell Linux the highest allowed D state for a device during probe.
+The support for _DSE requires support from the kernel bus type if the bus
+driver normally sets the device in D0 state for probe.
+
+The downside of using _DSE is that as the device is not powered on, even if
+there's a problem with the device, the driver likely probes just fine but the
+first user will find out the device doesn't work, instead of a failure at probe
+time. This feature should thus be used sparingly.
+
+I²C
+---
+
+If an I²C driver indicates its support for this by setting the
+I2C_DRV_ACPI_WAIVE_D0_PROBE flag in struct i2c_driver.flags field and the
+_DSE object evaluates to integer higher than the D state of the device,
+the device will not be powered on (put in D0 state) for probe.
+
+D states
+--------
+
+The D states and thus also the allowed values for _DSE are listed below. Refer
+to [1] for more information on device power states.
+
+.. code-block:: text
+
+ Number State Description
+ 0 D0 Device fully powered on
+ 1 D1
+ 2 D2
+ 3 D3hot
+ 4 D3cold Off
+
+References
+==========
+
+[1] https://uefi.org/specifications/ACPI/6.4/02_Definition_of_Terms/Definition_of_Terms.html#device-power-state-definitions
+
+Example
+=======
+
+An ASL example describing an ACPI device using _DSE object to tell Operating
+System the device should remain powered off during probe looks like this. Some
+objects not relevant from the example point of view have been omitted.
+
+.. code-block:: text
+
+ Device (CAM0)
+ {
+ Name (_HID, "SONY319A")
+ Name (_UID, Zero)
+ Name (_CRS, ResourceTemplate ()
+ {
+ I2cSerialBus(0x0020, ControllerInitiated, 0x00061A80,
+ AddressingMode7Bit, "\\_SB.PCI0.I2C0",
+ 0x00, ResourceConsumer)
+ })
+ Name (_DSE, 0, NotSerialized)
+ {
+ Return (0x4)
+ }
+ }