diff mbox series

[RFC,v3,2/3] regmap-irq: Add support for POLARITY_HI and POLARITY_LO config regs

Message ID 4b77a308ccdabbe96ed68623bd6eead9510e1fc9.1615423027.git.gurus@codeaurora.org
State New
Headers show
Series Add support for Qualcomm MFD PMIC register layout | expand

Commit Message

Guru Das Srinagesh March 11, 2021, 12:39 a.m. UTC 
If an interrupt is already configured as either edge- or
level-triggered, setting the corresponding bit for it in the POLARITY_HI
register further configures it as rising-edge or level-high triggered
(as the case may be), while setting the same bit in POLARITY_LO further
configures it as falling-edge or level-low triggered.

Therefore, in QCOM's case, the type_*_val are all to be configured as
BIT() masks.

These two new configuration registers are QCOM-specific and hence, the
code is not generic in its current form. I'm looking for feedback on how
this may be made generic.

Signed-off-by: Guru Das Srinagesh <gurus@codeaurora.org>
---
 drivers/base/regmap/regmap-irq.c | 67 ++++++++++++++++++++++++++++++++++++++++
 include/linux/regmap.h           |  4 +++
 2 files changed, 71 insertions(+)

Comments

Mark Brown March 12, 2021, 12:19 p.m. UTC | #1 
On Wed, Mar 10, 2021 at 04:39:53PM -0800, Guru Das Srinagesh wrote:
> If an interrupt is already configured as either edge- or
> level-triggered, setting the corresponding bit for it in the POLARITY_HI
> register further configures it as rising-edge or level-high triggered
> (as the case may be), while setting the same bit in POLARITY_LO further
> configures it as falling-edge or level-low triggered.

I think you probably need to bring these three fields together into a
single virtual field and then map the values within that field using
the existing type stuff.
diff mbox series

Patch

diff --git a/drivers/base/regmap/regmap-irq.c b/drivers/base/regmap/regmap-irq.c
index e1d8fc9e..cb13855 100644
--- a/drivers/base/regmap/regmap-irq.c
+++ b/drivers/base/regmap/regmap-irq.c
@@ -38,6 +38,8 @@  struct regmap_irq_chip_data {
 	unsigned int *wake_buf;
 	unsigned int *type_buf;
 	unsigned int *type_buf_def;
+	unsigned int *polarity_hi_buf;
+	unsigned int *polarity_lo_buf;
 
 	unsigned int irq_reg_stride;
 	unsigned int type_reg_stride;
@@ -215,6 +217,22 @@  static void regmap_irq_sync_unlock(struct irq_data *data)
 			if (ret != 0)
 				dev_err(d->map->dev, "Failed to sync type in %x\n",
 					reg);
+
+			if (!d->chip->polarity_hi_base ||
+			    !d->chip->polarity_lo_base)
+				continue;
+
+			reg = sub_irq_reg(d, d->chip->polarity_hi_base, i);
+			ret = regmap_write(map, reg, d->polarity_hi_buf[i]);
+			if (ret != 0)
+				dev_err(d->map->dev, "Failed to sync polarity hi in %x\n",
+					reg);
+
+			reg = sub_irq_reg(d, d->chip->polarity_lo_base, i);
+			ret = regmap_write(map, reg, d->polarity_lo_buf[i]);
+			if (ret != 0)
+				dev_err(d->map->dev, "Failed to sync polarity lo in %x\n",
+					reg);
 		}
 	}
 
@@ -318,6 +336,41 @@  static int regmap_irq_set_type(struct irq_data *data, unsigned int type)
 	default:
 		return -EINVAL;
 	}
+
+
+	if (d->chip->polarity_hi_base && d->chip->polarity_lo_base) {
+		switch (type) {
+		case IRQ_TYPE_EDGE_FALLING:
+			d->polarity_hi_buf[reg] &= ~t->type_falling_val;
+			d->polarity_lo_buf[reg] |= t->type_falling_val;
+			break;
+
+		case IRQ_TYPE_EDGE_RISING:
+			d->polarity_hi_buf[reg] |= t->type_rising_val;
+			d->polarity_lo_buf[reg] &= ~t->type_rising_val;
+			break;
+
+		case IRQ_TYPE_EDGE_BOTH:
+			d->polarity_hi_buf[reg] |= (t->type_falling_val |
+					t->type_rising_val);
+			d->polarity_lo_buf[reg] |= (t->type_falling_val |
+					t->type_rising_val);
+			break;
+
+		case IRQ_TYPE_LEVEL_HIGH:
+			d->polarity_hi_buf[reg] |= t->type_level_high_val;
+			d->polarity_lo_buf[reg] &= ~t->type_level_high_val;
+			break;
+
+		case IRQ_TYPE_LEVEL_LOW:
+			d->polarity_hi_buf[reg] &= ~t->type_level_low_val;
+			d->polarity_lo_buf[reg] |= t->type_level_low_val;
+			break;
+		default:
+			return -EINVAL;
+		}
+	}
+
 	return 0;
 }
 
@@ -691,6 +744,16 @@  int regmap_add_irq_chip_fwnode(struct fwnode_handle *fwnode,
 			goto err_alloc;
 	}
 
+	d->polarity_hi_buf = kcalloc(chip->num_regs, sizeof(unsigned int),
+				     GFP_KERNEL);
+	if (!d->polarity_hi_buf)
+		goto err_alloc;
+
+	d->polarity_lo_buf = kcalloc(chip->num_regs, sizeof(unsigned int),
+				     GFP_KERNEL);
+	if (!d->polarity_lo_buf)
+		goto err_alloc;
+
 	d->irq_chip = regmap_irq_chip;
 	d->irq_chip.name = chip->name;
 	d->irq = irq;
@@ -857,6 +920,8 @@  int regmap_add_irq_chip_fwnode(struct fwnode_handle *fwnode,
 	/* Should really dispose of the domain but... */
 err_alloc:
 	kfree(d->type_buf);
+	kfree(d->polarity_hi_buf);
+	kfree(d->polarity_lo_buf);
 	kfree(d->type_buf_def);
 	kfree(d->wake_buf);
 	kfree(d->mask_buf_def);
@@ -927,6 +992,8 @@  void regmap_del_irq_chip(int irq, struct regmap_irq_chip_data *d)
 
 	irq_domain_remove(d->domain);
 	kfree(d->type_buf);
+	kfree(d->polarity_hi_buf);
+	kfree(d->polarity_lo_buf);
 	kfree(d->type_buf_def);
 	kfree(d->wake_buf);
 	kfree(d->mask_buf_def);
diff --git a/include/linux/regmap.h b/include/linux/regmap.h
index 18910bd..0f1329d 100644
--- a/include/linux/regmap.h
+++ b/include/linux/regmap.h
@@ -1393,6 +1393,8 @@  struct regmap_irq_sub_irq_map {
  *               Using zero value is possible with @use_ack bit.
  * @wake_base:   Base address for wake enables.  If zero unsupported.
  * @type_base:   Base address for irq type.  If zero unsupported.
+ * @polarity_hi_base: Base address for specifying edge- or level-high triggered
+ * @polarity_lo_base: Base address for specifying edge- or level-low triggered
  * @irq_reg_stride:  Stride to use for chips where registers are not contiguous.
  * @init_ack_masked: Ack all masked interrupts once during initalization.
  * @mask_invert: Inverted mask register: cleared bits are masked out.
@@ -1444,6 +1446,8 @@  struct regmap_irq_chip {
 	unsigned int ack_base;
 	unsigned int wake_base;
 	unsigned int type_base;
+	unsigned int polarity_hi_base;
+	unsigned int polarity_lo_base;
 	unsigned int irq_reg_stride;
 	bool mask_writeonly:1;
 	bool init_ack_masked:1;