@@ -4,6 +4,7 @@
*/
/dts-v1/;
+#include <dt-bindings/interrupt-controller/irq.h>
#include "ste-nomadik-stn8815.dtsi"
/ {
@@ -14,14 +15,6 @@
bootargs = "root=/dev/ram0 console=ttyAMA1,115200n8 earlyprintk";
};
- /* This is where the interrupt is routed on the S8815 board */
- external-bus@34000000 {
- ethernet@300 {
- interrupt-parent = <&gpio3>;
- interrupts = <8 0x1>;
- };
- };
-
src@101e0000 {
/* These chrystal drivers are not used on this board */
disable-sxtalo;
@@ -73,6 +66,21 @@
};
};
+ /* Ethernet */
+ external-bus@34000000 {
+ compatible = "simple-bus";
+ reg = <0x34000000 0x1000000>;
+ #address-cells = <1>;
+ #size-cells = <1>;
+ ranges = <0 0x34000000 0x1000000>;
+ ethernet@300 {
+ compatible = "smsc,lan91c111";
+ reg = <0x300 0x0fd00>;
+ interrupt-parent = <&gpio3>;
+ interrupts = <8 IRQ_TYPE_EDGE_RISING>;
+ };
+ };
+
/* GPIO I2C connected to the USB portions of the STw4811 only */
gpio-i2c {
compatible = "i2c-gpio";
@@ -673,18 +673,6 @@
};
};
- external-bus@34000000 {
- compatible = "simple-bus";
- reg = <0x34000000 0x1000000>;
- #address-cells = <1>;
- #size-cells = <1>;
- ranges = <0 0x34000000 0x1000000>;
- ethernet@300 {
- compatible = "smsc,lan91c111";
- reg = <0x300 0x0fd00>;
- };
- };
-
/* I2C0 connected to the STw4811 power management chip */
i2c0 {
compatible = "st,nomadik-i2c", "arm,primecell";
The SoC file defines the location and type of the ethernet adapter, this should be in the per-board file, as it is by no means necessary to have an ethernet adapter connected to this memory space. Signed-off-by: Linus Walleij <linus.walleij@linaro.org> --- arch/arm/boot/dts/ste-nomadik-s8815.dts | 24 ++++++++++++++++-------- arch/arm/boot/dts/ste-nomadik-stn8815.dtsi | 12 ------------ 2 files changed, 16 insertions(+), 20 deletions(-)