diff mbox

[v3,03/10] ARM: dts: dra7-evm: Add CAN support

Message ID 1415098134-26405-4-git-send-email-rogerq@ti.com
State New
Headers show

Commit Message

Roger Quadros Nov. 4, 2014, 10:48 a.m. UTC
The board has 2 CAN ports but only the first one can be used.
Enable the first CAN port.

WAKEUP0 pin doesn't have INPUT enable bit so we just disable
weak PULLs.

The second CAN port cannot be used without hardware modification
so we don't enable the second port.

Signed-off-by: Roger Quadros <rogerq@ti.com>
---
 arch/arm/boot/dts/dra7-evm.dts | 23 +++++++++++++++++++++++
 1 file changed, 23 insertions(+)
diff mbox

Patch

diff --git a/arch/arm/boot/dts/dra7-evm.dts b/arch/arm/boot/dts/dra7-evm.dts
index c6ce625..8c2c37b 100644
--- a/arch/arm/boot/dts/dra7-evm.dts
+++ b/arch/arm/boot/dts/dra7-evm.dts
@@ -171,6 +171,22 @@ 
 			0xd0	(PIN_OUTPUT | MUX_MODE0)	/* gpmc_be0n_cle */
 		>;
 	};
+
+	dcan1_pins_default: dcan1_pins_default {
+		pinctrl-single,pins = <
+			0x3d0   (PIN_OUTPUT | MUX_MODE0) /* dcan1_tx */
+			0x3d4   (MUX_MODE15)		/* dcan1_rx.off */
+			0x418   (PULL_DIS | MUX_MODE1) /* wakeup0.dcan1_rx */
+		>;
+	};
+
+	dcan1_pins_sleep: dcan1_pins_sleep {
+		pinctrl-single,pins = <
+			0x3d0   (MUX_MODE15)	/* dcan1_tx.off */
+			0x3d4   (MUX_MODE15)	/* dcan1_rx.off */
+			0x418   (MUX_MODE15)	/* wakeup0.off */
+		>;
+	};
 };
 
 &i2c1 {
@@ -528,3 +544,10 @@ 
 	ti,no-reset-on-init;
 	ti,no-idle-on-init;
 };
+
+&dcan1 {
+	status = "ok";
+	pinctrl-names = "default", "sleep";
+	pinctrl-0 = <&dcan1_pins_default>;
+	pinctrl-1 = <&dcan1_pins_sleep>;
+};