@@ -119,6 +119,16 @@ struct regulator_dev;
#define REGULATOR_EVENT_PRE_DISABLE 0x400
#define REGULATOR_EVENT_ABORT_DISABLE 0x800
#define REGULATOR_EVENT_ENABLE 0x1000
+/*
+ * Following notifications should be emitted only if detected condition
+ * is such that the HW is likely to still be working but consumers should
+ * take a recovery action to prevent problems esacalating into errors.
+ */
+#define REGULATOR_EVENT_UNDER_VOLTAGE_WARN 0x2000
+#define REGULATOR_EVENT_OVER_CURRENT_WARN 0x4000
+#define REGULATOR_EVENT_OVER_VOLTAGE_WARN 0x8000
+#define REGULATOR_EVENT_OVER_TEMP_WARN 0x10000
+#define REGULATOR_EVENT_WARN_MASK 0x1E000
/*
* Regulator errors that can be queried using regulator_get_error_flags
@@ -138,6 +148,10 @@ struct regulator_dev;
#define REGULATOR_ERROR_FAIL BIT(4)
#define REGULATOR_ERROR_OVER_TEMP BIT(5)
+#define REGULATOR_ERROR_UNDER_VOLTAGE_WARN BIT(6)
+#define REGULATOR_ERROR_OVER_CURRENT_WARN BIT(7)
+#define REGULATOR_ERROR_OVER_VOLTAGE_WARN BIT(8)
+#define REGULATOR_ERROR_OVER_TEMP_WARN BIT(9)
/**
* struct pre_voltage_change_data - Data sent with PRE_VOLTAGE_CHANGE event
Add 'warning' level events and error flags to regulator core. Current regulator core notifications are used to inform consumers about errors where HW is misbehaving in such way it is assumed to be broken/unrecoverable. There are PMICs which are designed for system(s) that may have use for regulator indications sent before HW is damaged so that some board/consumer specific recovery-event can be performed while continuing most of the normal operations. Add new WARNING level events and notifications to be used for that purpose. Signed-off-by: Matti Vaittinen <matti.vaittinen@fi.rohmeurope.com> --- No changes since RFC-v2 --- include/linux/regulator/consumer.h | 14 ++++++++++++++ 1 file changed, 14 insertions(+)