@@ -978,22 +978,28 @@ static int m88e1111_get_downshift(struct phy_device *phydev, u8 *data)
static int m88e1111_set_downshift(struct phy_device *phydev, u8 cnt)
{
- int val;
+ int val, err;
if (cnt > MII_M1111_PHY_EXT_CR_DOWNSHIFT_MAX)
return -E2BIG;
- if (!cnt)
- return phy_clear_bits(phydev, MII_M1111_PHY_EXT_CR,
- MII_M1111_PHY_EXT_CR_DOWNSHIFT_EN);
+ if (!cnt) {
+ err = phy_clear_bits(phydev, MII_M1111_PHY_EXT_CR,
+ MII_M1111_PHY_EXT_CR_DOWNSHIFT_EN);
+ } else {
+ val = MII_M1111_PHY_EXT_CR_DOWNSHIFT_EN;
+ val |= FIELD_PREP(MII_M1111_PHY_EXT_CR_DOWNSHIFT_MASK, cnt - 1);
- val = MII_M1111_PHY_EXT_CR_DOWNSHIFT_EN;
- val |= FIELD_PREP(MII_M1111_PHY_EXT_CR_DOWNSHIFT_MASK, cnt - 1);
+ err = phy_modify(phydev, MII_M1111_PHY_EXT_CR,
+ MII_M1111_PHY_EXT_CR_DOWNSHIFT_EN |
+ MII_M1111_PHY_EXT_CR_DOWNSHIFT_MASK,
+ val);
+ }
- return phy_modify(phydev, MII_M1111_PHY_EXT_CR,
- MII_M1111_PHY_EXT_CR_DOWNSHIFT_EN |
- MII_M1111_PHY_EXT_CR_DOWNSHIFT_MASK,
- val);
+ if (err < 0)
+ return err;
+
+ return genphy_soft_reset(phydev);
}
static int m88e1111_get_tunable(struct phy_device *phydev,
Changing downshift params without software reset has no effect, so call genphy_soft_reset() after change downshift params. As the datasheet says: Changes to these bits are disruptive to the normal operation therefore, any changes to these registers must be followed by software reset to take effect. Fixes: 5c6bc5199b5d ("net: phy: marvell: add downshift support for M88E1111") Signed-off-by: Maxim Kochetkov <fido_max@inbox.ru> --- drivers/net/phy/marvell.c | 26 ++++++++++++++++---------- 1 file changed, 16 insertions(+), 10 deletions(-)