@@ -712,7 +712,8 @@ config BATTERY_GOLDFISH
config BATTERY_RT5033
tristate "RT5033 fuel gauge support"
- depends on MFD_RT5033
+ depends on I2C
+ select REGMAP_I2C
help
This adds support for battery fuel gauge in Richtek RT5033 PMIC.
The fuelgauge calculates and determines the battery state of charge
@@ -164,9 +164,16 @@ static const struct i2c_device_id rt5033_battery_id[] = {
};
MODULE_DEVICE_TABLE(i2c, rt5033_battery_id);
+static const struct of_device_id rt5033_battery_of_match[] = {
+ { .compatible = "richtek,rt5033-battery", },
+ { }
+};
+MODULE_DEVICE_TABLE(of, rt5033_battery_dt_match);
+
static struct i2c_driver rt5033_battery_driver = {
.driver = {
.name = "rt5033-battery",
+ .of_match_table = rt5033_battery_of_match,
},
.probe = rt5033_battery_probe,
.remove = rt5033_battery_remove,
The fuel gauge in the RT5033 PMIC has its own I2C bus and interrupt line. Therefore, it is not actually part of the RT5033 MFD and needs its own of_match_table to probe properly. Also, given that it's independent of the MFD, there is actually no need to make the Kconfig depend on MFD_RT5033. Although the driver uses the shared <linux/mfd/rt5033.h> header, there is no compile or runtime dependency on the RT5033 MFD driver. Cc: Beomho Seo <beomho.seo@samsung.com> Cc: Chanwoo Choi <cw00.choi@samsung.com> Fixes: b847dd96e659 ("power: rt5033_battery: Add RT5033 Fuel gauge device driver") Signed-off-by: Stephan Gerhold <stephan@gerhold.net> --- drivers/power/supply/Kconfig | 3 ++- drivers/power/supply/rt5033_battery.c | 7 +++++++ 2 files changed, 9 insertions(+), 1 deletion(-)