@@ -19,14 +19,14 @@ Module Name:
Abstract:
- AMD8111 based 10/100 Ethernet Controller Driver.
+ AMD8111 based 10/100 Ethernet Controller Driver.
Environment:
Kernel Mode
Revision History:
- 3.0.0
+ 3.0.0
Initial Revision.
3.0.1
1. Dynamic interrupt coalescing.
@@ -10,14 +10,14 @@ Module Name:
Abstract:
- AMD8111 based 10/100 Ethernet Controller driver definitions.
+ AMD8111 based 10/100 Ethernet Controller driver definitions.
Environment:
Kernel Mode
Revision History:
- 3.0.0
+ 3.0.0
Initial Revision.
3.0.1
*/
@@ -692,7 +692,7 @@ enum coal_type{
};
enum coal_mode{
- RX_INTR_COAL,
+ RX_INTR_COAL,
TX_INTR_COAL,
DISABLE_COAL,
ENABLE_COAL,
@@ -706,7 +706,7 @@ static void lance_init_ring( struct net_device *dev )
CHECK_OFFSET(offset);
MEM->tx_head[i].base = offset;
MEM->tx_head[i].flag = TMD1_OWN_HOST;
- MEM->tx_head[i].base_hi = 0;
+ MEM->tx_head[i].base_hi = 0;
MEM->tx_head[i].length = 0;
MEM->tx_head[i].misc = 0;
offset += PKT_BUF_SZ;
@@ -937,7 +937,7 @@ static netdev_tx_t lance_start_xmit(struct sk_buff *skb, struct net_device *dev)
dev_kfree_skb(skb);
- return NETDEV_TX_OK;
+ return NETDEV_TX_OK;
}
static void lance_load_multicast(struct net_device *dev)
@@ -780,7 +780,7 @@ lance_open(struct net_device *dev)
outw(0x0002, ioaddr+LANCE_ADDR);
/* Only touch autoselect bit. */
outw(inw(ioaddr+LANCE_BUS_IF) | 0x0002, ioaddr+LANCE_BUS_IF);
- }
+ }
if (lance_debug > 1)
printk("%s: lance_open() irq %d dma %d tx/rx rings %#x/%#x init %#x.\n",
@@ -812,7 +812,7 @@ lance_open(struct net_device *dev)
* We used to clear the InitDone bit, 0x0100, here but Mark Stockton
* reports that doing so triggers a bug in the '974.
*/
- outw(0x0042, ioaddr+LANCE_DATA);
+ outw(0x0042, ioaddr+LANCE_DATA);
if (lance_debug > 2)
printk("%s: LANCE open after %d ticks, init block %#x csr0 %4.4x.\n",
@@ -193,7 +193,7 @@ static struct card {
.vendor_id = ni_vendor,
.cardname = "ni6510",
.config = 0x1,
- },
+ },
{
.id0 = NI65_EB_ID0,
.id1 = NI65_EB_ID1,
@@ -204,7 +204,7 @@ static struct card {
.vendor_id = ni_vendor,
.cardname = "ni6510 EtherBlaster",
.config = 0x2,
- },
+ },
{
.id0 = NE2100_ID0,
.id1 = NE2100_ID1,
@@ -1232,15 +1232,15 @@ MODULE_PARM_DESC(dma, "ni6510 ISA DMA channel (ignored for some cards)");
int __init init_module(void)
{
- dev_ni65 = ni65_probe(-1);
+ dev_ni65 = ni65_probe(-1);
return PTR_ERR_OR_ZERO(dev_ni65);
}
void __exit cleanup_module(void)
{
- unregister_netdev(dev_ni65);
- cleanup_card(dev_ni65);
- free_netdev(dev_ni65);
+ unregister_netdev(dev_ni65);
+ cleanup_card(dev_ni65);
+ free_netdev(dev_ni65);
}
#endif /* MODULE */
@@ -541,7 +541,7 @@ static int mace_init(mace_private *lp, unsigned int ioaddr, char *enet_addr)
if(++ct > 500)
{
pr_err("reset failed, card removed?\n");
- return -1;
+ return -1;
}
udelay(1);
}
@@ -585,11 +585,11 @@ static int mace_init(mace_private *lp, unsigned int ioaddr, char *enet_addr)
ct = 0;
while (mace_read(lp, ioaddr, MACE_IAC) & MACE_IAC_ADDRCHG)
{
- if(++ ct > 500)
- {
+ if(++ ct > 500)
+ {
pr_err("ADDRCHG timeout, card removed?\n");
- return -1;
- }
+ return -1;
+ }
}
/* Set PADR register */
for (i = 0; i < ETH_ALEN; i++)
@@ -655,7 +655,7 @@ static int nmclan_config(struct pcmcia_device *link)
}
if(mace_init(lp, ioaddr, dev->dev_addr) == -1)
- goto failed;
+ goto failed;
/* The if_port symbol can be set when the module is loaded */
if (if_port <= 2)
@@ -150,7 +150,7 @@ struct lance_memory {
struct lance_private {
volatile unsigned short *iobase;
struct lance_memory *mem;
- int new_rx, new_tx; /* The next free ring entry */
+ int new_rx, new_tx; /* The next free ring entry */
int old_tx, old_rx; /* ring entry to be processed */
/* These two must be longs for set_bit() */
long tx_full;
@@ -465,7 +465,7 @@ static void lance_init_ring( struct net_device *dev )
for( i = 0; i < TX_RING_SIZE; i++ ) {
MEM->tx_head[i].base = dvma_vtob(MEM->tx_data[i]);
MEM->tx_head[i].flag = 0;
- MEM->tx_head[i].base_hi =
+ MEM->tx_head[i].base_hi =
(dvma_vtob(MEM->tx_data[i])) >>16;
MEM->tx_head[i].length = 0;
MEM->tx_head[i].misc = 0;
@@ -581,8 +581,8 @@ lance_start_xmit(struct sk_buff *skb, struct net_device *dev)
}
AREG = CSR0;
- DPRINTK( 2, ( "%s: lance_start_xmit() called, csr0 %4.4x.\n",
- dev->name, DREG ));
+ DPRINTK( 2, ( "%s: lance_start_xmit() called, csr0 %4.4x.\n",
+ dev->name, DREG ));
#ifdef CONFIG_SUN3X
/* this weirdness doesn't appear on sun3... */
@@ -636,8 +636,8 @@ lance_start_xmit(struct sk_buff *skb, struct net_device *dev)
/* Trigger an immediate send poll. */
REGA(CSR0) = CSR0_INEA | CSR0_TDMD | CSR0_STRT;
AREG = CSR0;
- DPRINTK( 2, ( "%s: lance_start_xmit() exiting, csr0 %4.4x.\n",
- dev->name, DREG ));
+ DPRINTK( 2, ( "%s: lance_start_xmit() exiting, csr0 %4.4x.\n",
+ dev->name, DREG ));
dev_kfree_skb(skb);
lp->lock = 0;
There are a few leading spaces before tabs and remove it by running the following commard: $ find . -name '*.c' | xargs sed -r -i 's/^[ ]+\t/\t/' $ find . -name '*.h' | xargs sed -r -i 's/^[ ]+\t/\t/' Signed-off-by: Hui Tang <tanghui20@huawei.com> --- drivers/net/ethernet/amd/amd8111e.c | 4 ++-- drivers/net/ethernet/amd/amd8111e.h | 6 +++--- drivers/net/ethernet/amd/atarilance.c | 2 +- drivers/net/ethernet/amd/declance.c | 2 +- drivers/net/ethernet/amd/lance.c | 4 ++-- drivers/net/ethernet/amd/ni65.c | 12 ++++++------ drivers/net/ethernet/amd/nmclan_cs.c | 12 ++++++------ drivers/net/ethernet/amd/sun3lance.c | 12 ++++++------ 8 files changed, 27 insertions(+), 27 deletions(-)