@@ -44,6 +44,40 @@ For example:
clocks by index. The names should reflect the clock output signal
names for the device.
+clock-always-on: Some hardware contains bunches of clocks which must never be
+ turned off. If drivers a) fail to obtain a reference to any
+ of these or b) give up a previously obtained reference
+ during suspend, the common clk framework will attempt to
+ disable them and a platform can fail irrecoverably as a
+ result. Usually the only way to recover from these failures
+ is to reboot.
+
+ To avoid either of these two scenarios from catastrophically
+ disabling an otherwise perfectly healthy running system,
+ clocks can be identified as always-on using this property
+ from inside a clocksource's node. The CLK_IGNORE_UNUSED
+ flag will be applied to each clock instance named in this
+ property, thus preventing them from being shut down by the
+ framework.
+
+ This property is not to be abused. It is only to be used to
+ protect platforms from being crippled by gated clocks, not
+ as a convenience function to avoid using the framework
+ correctly inside device drivers.
+
+For example:
+
+ oscillator {
+ #clock-cells = <1>;
+ clock-output-names = "ckil", "ckih";
+ clock-always-on = "ckil";
+ };
+
+- this node defines a device with two clock outputs, just as in the
+ example above. The only difference being that 'ckil' is now
+ identified as an always-on clock, so the framework will know to
+ never attempt to gate it.
+
clock-indices: If the identifying number for the clocks in the node
is not linear from zero, then this allows the mapping of
identifiers into the clock-output-names array.
Signed-off-by: Lee Jones <lee.jones@linaro.org> --- .../devicetree/bindings/clock/clock-bindings.txt | 34 ++++++++++++++++++++++ 1 file changed, 34 insertions(+)