@@ -686,6 +686,16 @@ static int imx7d_charger_secondary_detection(struct imx_usbmisc_data *data)
int val;
unsigned long flags;
+ /* Clear VDATSRCENB0 to disable VDP_SRC and IDM_SNK required by BC 1.2 spec */
+ spin_lock_irqsave(&usbmisc->lock, flags);
+ val = readl(usbmisc->base + MX7D_USB_OTG_PHY_CFG2);
+ val &= ~MX7D_USB_OTG_PHY_CFG2_CHRG_VDATSRCENB0;
+ writel(val, usbmisc->base + MX7D_USB_OTG_PHY_CFG2);
+ spin_unlock_irqrestore(&usbmisc->lock, flags);
+
+ /* TVDMSRC_DIS */
+ msleep(20);
+
/* VDM_SRC is connected to D- and IDP_SINK is connected to D+ */
spin_lock_irqsave(&usbmisc->lock, flags);
val = readl(usbmisc->base + MX7D_USB_OTG_PHY_CFG2);
@@ -695,7 +705,8 @@ static int imx7d_charger_secondary_detection(struct imx_usbmisc_data *data)
usbmisc->base + MX7D_USB_OTG_PHY_CFG2);
spin_unlock_irqrestore(&usbmisc->lock, flags);
- usleep_range(1000, 2000);
+ /* TVDMSRC_ON */
+ msleep(40);
/*
* Per BC 1.2, check voltage of D+:
@@ -798,7 +809,8 @@ static int imx7d_charger_primary_detection(struct imx_usbmisc_data *data)
usbmisc->base + MX7D_USB_OTG_PHY_CFG2);
spin_unlock_irqrestore(&usbmisc->lock, flags);
- usleep_range(1000, 2000);
+ /* TVDPSRC_ON */
+ msleep(40);
/* Check if D- is less than VDAT_REF to determine an SDP per BC 1.2 */
val = readl(usbmisc->base + MX7D_USB_OTG_PHY_STATUS);
i.MX8MM cannot detect certain CDP USB HUBs. usbmisc_imx.c driver is not following CDP timing requirements defined by USB BC 1.2 specification and section 3.2.4 Detection Timing CDP. During Primary Detection the i.MX device should turn on VDP_SRC and IDM_SINK for a minimum of 40ms (TVDPSRC_ON). After a time of TVDPSRC_ON, the i.MX is allowed to check the status of the D- line. Current implementation is waiting between 1ms and 2ms, and certain BC 1.2 complaint USB HUBs cannot be detected. Increase delay to 40ms allowing enough time for primary detection. During secondary detection the i.MX is required to disable VDP_SRC and IDM_SNK, and enable VDM_SRC and IDP_SINK for at least 40ms (TVDMSRC_ON). Current implementation is not disabling VDP_SRC and IDM_SNK, introduce disable sequence in imx7d_charger_secondary_detection() function. VDM_SRC and IDP_SINK should be enabled for at least 40ms (TVDMSRC_ON). Increase delay allowing enough time for detection. Fixes: 746f316b753a ("usb: chipidea: introduce imx7d USB charger detection") Signed-off-by: Breno Lima <breno.lima@nxp.com> Signed-off-by: Jun Li <jun.li@nxp.com> --- Changes since V2: - Updated commit title as SW change also applies to i.MX7D device. - Updated commit log based on comments made by Peter Chen <peter.chen@kernel.org>. Changes since V1: - Updated commit log to include commit ID fix as suggested by Jun Li <jun.li@nxp.com>. drivers/usb/chipidea/usbmisc_imx.c | 16 ++++++++++++++-- 1 file changed, 14 insertions(+), 2 deletions(-)