@@ -199,6 +199,7 @@ nodes to be present and contain the properties described below.
"qcom,kpss-acc-v1"
"qcom,kpss-acc-v2"
"rockchip,rk3066-smp"
+ "ste,dbx500-smp"
- cpu-release-addr
Usage: required for systems that have an "enable-method"
@@ -15,6 +15,33 @@
#include "skeleton.dtsi"
/ {
+ cpus {
+ #address-cells = <1>;
+ #size-cells = <0>;
+ enable-method = "ste,dbx500-smp";
+
+ cpu-map {
+ cluster0 {
+ core0 {
+ cpu = <&CPU0>;
+ };
+ core1 {
+ cpu = <&CPU1>;
+ };
+ };
+ };
+ CPU0: cpu@300 {
+ device_type = "cpu";
+ compatible = "arm,cortex-a9";
+ reg = <0x300>;
+ };
+ CPU1: cpu@301 {
+ device_type = "cpu";
+ compatible = "arm,cortex-a9";
+ reg = <0x301>;
+ };
+ };
+
soc {
#address-cells = <1>;
#size-cells = <1>;
@@ -22,32 +49,6 @@
interrupt-parent = <&intc>;
ranges;
- cpus {
- #address-cells = <1>;
- #size-cells = <0>;
-
- cpu-map {
- cluster0 {
- core0 {
- cpu = <&CPU0>;
- };
- core1 {
- cpu = <&CPU1>;
- };
- };
- };
- CPU0: cpu@0 {
- device_type = "cpu";
- compatible = "arm,cortex-a9";
- reg = <0>;
- };
- CPU1: cpu@1 {
- device_type = "cpu";
- compatible = "arm,cortex-a9";
- reg = <1>;
- };
- };
-
ptm@801ae000 {
compatible = "arm,coresight-etm3x", "arm,primecell";
reg = <0x801ae000 0x1000>;
The "cpus" node cannot be inside the "soc" node, while this works for the CoreSight blocks, the early boot code will look for "cpus" directly under the root node, so this is a hard convention. So move the CPU nodes. Augment the "reg" property to match what is actually in the hardware: 0x300 and 0x301 respectively. Then add an SMP enablement type to be used by the SMP init code, "ste,dbx500-smp". Signed-off-by: Linus Walleij <linus.walleij@linaro.org> --- Documentation/devicetree/bindings/arm/cpus.txt | 1 + arch/arm/boot/dts/ste-dbx5x0.dtsi | 53 +++++++++++++------------- 2 files changed, 28 insertions(+), 26 deletions(-)