@@ -715,6 +715,7 @@ static void ath10k_send_suspend_complete(struct ath10k *ar)
static int ath10k_init_sdio(struct ath10k *ar, enum ath10k_firmware_mode mode)
{
+ bool mtu_workaround = ar->hw_params.credit_size_workaround;
int ret;
u32 param = 0;
@@ -732,7 +733,7 @@ static int ath10k_init_sdio(struct ath10k *ar, enum ath10k_firmware_mode mode)
param |= HI_ACS_FLAGS_SDIO_REDUCE_TX_COMPL_SET;
- if (mode == ATH10K_FIRMWARE_MODE_NORMAL)
+ if (mode == ATH10K_FIRMWARE_MODE_NORMAL && !mtu_workaround)
param |= HI_ACS_FLAGS_ALT_DATA_CREDIT_SIZE;
else
param &= ~HI_ACS_FLAGS_ALT_DATA_CREDIT_SIZE;
@@ -618,6 +618,9 @@ struct ath10k_hw_params {
*/
bool uart_pin_workaround;
+ /* Workaround for the credit size calculation */
+ bool credit_size_workaround;
+
/* tx stats support over pktlog */
bool tx_stats_over_pktlog;
On an imx6dl-pico-pi board with a QCA9377 SDIO chip, simply trying to connect via ssh to another machine causes: [ 55.824159] ath10k_sdio mmc1:0001:1: failed to transmit packet, dropping: -12 [ 55.832169] ath10k_sdio mmc1:0001:1: failed to submit frame: -12 [ 55.838529] ath10k_sdio mmc1:0001:1: failed to push frame: -12 [ 55.905863] ath10k_sdio mmc1:0001:1: failed to transmit packet, dropping: -12 [ 55.913650] ath10k_sdio mmc1:0001:1: failed to submit frame: -12 [ 55.919887] ath10k_sdio mmc1:0001:1: failed to push frame: -12 , leading to an ssh connection failure. One user inspected the size of frames on Wireshark and reported the followig: "I was able to narrow the issue down to the mtu. If I set the mtu for the wlan0 device to 1486 instead of 1500, the issue does not happen. The size of frames that I see on Wireshark is exactly 1500 after setting it to 1486." Clearing the HI_ACS_FLAGS_ALT_DATA_CREDIT_SIZE avoids the problem and the ssh command works successfully after that. Introduce a 'credit_size_workaround' field to ath10k_hw_params for the QCA9377 SDIO, so that the HI_ACS_FLAGS_ALT_DATA_CREDIT_SIZE is not set in this case. Tested with QCA9377 SDIO with firmware WLAN.TF.1.1.1-00061-QCATFSWPZ-1. Fixes: 2f918ea98606 ("ath10k: enable alt data of TX path for sdio") Signed-off-by: Fabio Estevam <festevam@denx.de> --- Changes since v1: - Restrict the workaround only for QCA9377 SDIO drivers/net/wireless/ath/ath10k/core.c | 3 ++- drivers/net/wireless/ath/ath10k/hw.h | 3 +++ 2 files changed, 5 insertions(+), 1 deletion(-)