diff mbox series

[v2,1/4] Bluetooth: Reset more state when cancelling a sync command

Message ID 20211203145902.3223861-2-benjamin@sipsolutions.net
State New
Headers show
Series Cancel sync commands if a TX failure occurs | expand

Commit Message

Benjamin Berg Dec. 3, 2021, 2:58 p.m. UTC 
From: Benjamin Berg <bberg@redhat.com>

Resetting the timers and cmd_cnt means that we assume the device will be
in a good state after the sync command finishes. Without this a chain of
synchronous commands might get stuck if one of them is cancelled.

Signed-off-by: Benjamin Berg <bberg@redhat.com>
---
 net/bluetooth/hci_request.c | 5 +++++
 1 file changed, 5 insertions(+)
diff mbox series

Patch

diff --git a/net/bluetooth/hci_request.c b/net/bluetooth/hci_request.c
index 8b3205e4b23e..58d640a31bde 100644
--- a/net/bluetooth/hci_request.c
+++ b/net/bluetooth/hci_request.c
@@ -118,6 +118,11 @@  void hci_req_sync_cancel(struct hci_dev *hdev, int err)
 	if (hdev->req_status == HCI_REQ_PEND) {
 		hdev->req_result = err;
 		hdev->req_status = HCI_REQ_CANCELED;
+
+		cancel_delayed_work_sync(&hdev->cmd_timer);
+		cancel_delayed_work_sync(&hdev->ncmd_timer);
+		atomic_set(&hdev->cmd_cnt, 1);
+
 		wake_up_interruptible(&hdev->req_wait_q);
 	}
 }