@@ -82,6 +82,31 @@ properties:
description:
Delay, in microseconds, after a write transfer.
+ stacked-memories:
+ description: Several SPI memories can be wired in stacked mode.
+ This basically means that either a device features several chip
+ selects, or that different devices must be seen as a single
+ bigger chip. This basically doubles (or more) the total address
+ space with only a single additional wire, while still needing
+ to repeat the commands when crossing a chip boundary. The size of
+ each chip should be provided as members of the array.
+ $ref: /schemas/types.yaml#/definitions/uint64-array
+ minItems: 2
+ maxItems: 4
+
+ parallel-memories:
+ description: Several SPI memories can be wired in parallel mode.
+ The devices are physically on a different buses but will always
+ act synchronously as each data word is spread across the
+ different memories (eg. even bits are stored in one memory, odd
+ bits in the other). This basically doubles the address space and
+ the throughput while greatly complexifying the wiring because as
+ many busses as devices must be wired. The size of each chip should
+ be provided as members of the array.
+ $ref: /schemas/types.yaml#/definitions/uint64-array
+ minItems: 2
+ maxItems: 4
+
# The controller specific properties go here.
allOf:
- $ref: cdns,qspi-nor-peripheral-props.yaml#
Describe two new memories modes: - A stacked mode when the bus is common but the address space extended with an additinals wires. - A parallel mode with parallel busses accessing parallel flashes where the data is spread. Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com> --- Hello Rob, I know the below does not pass the tests (at least the example patch 3 does not pass) but I believe the issue is probably on the tooling side because the exact same thing with uing32-array instead is accepted. The problem comes from the minItems/maxItems lines. Without them, this is okay. The maxItems btw matches the "good enough value for now" idea. The errors I get are: $ make dt_binding_check DT_SCHEMA_FILES=Documentation/devicetree/bindings/spi/spi-controller.yaml LINT Documentation/devicetree/bindings CHKDT Documentation/devicetree/bindings/processed-schema-examples.json SCHEMA Documentation/devicetree/bindings/processed-schema-examples.json DTEX Documentation/devicetree/bindings/spi/spi-controller.example.dts DTC Documentation/devicetree/bindings/spi/spi-controller.example.dt.yaml CHECK Documentation/devicetree/bindings/spi/spi-controller.example.dt.yaml /src/Documentation/devicetree/bindings/spi/spi-controller.example.dt.yaml: spi@80010000: flash@2:stacked-memories: [[268435456, 268435456]] is too short From schema: /src/Documentation/devicetree/bindings/spi/spi-controller.yaml /src/Documentation/devicetree/bindings/spi/spi-controller.example.dt.yaml: spi@80010000: flash@2:stacked-memories: [[268435456, 268435456]] is too short From schema: /src/Documentation/devicetree/bindings/spi/mxs-spi.yaml /src/Documentation/devicetree/bindings/spi/spi-controller.example.dt.yaml: spi@80010000: Unevaluated properties are not allowed ('#address-cells', '#size-cells', 'display@0', 'sensor@1', 'flash@2' were unexpected) From schema: /src/Documentation/devicetree/bindings/spi/mxs-spi.yaml /src/Documentation/devicetree/bindings/spi/spi-controller.example.dt.yaml: flash@2: stacked-memories: [[268435456, 268435456]] is too short From schema: /src/Documentation/devicetree/bindings/mtd/jedec,spi-nor.yaml .../bindings/spi/spi-peripheral-props.yaml | 25 +++++++++++++++++++ 1 file changed, 25 insertions(+)