@@ -24,6 +24,7 @@ struct display_connector {
int hpd_irq;
struct regulator *dp_pwr;
+ struct gpio_desc *ddc_en;
};
static inline struct display_connector *
@@ -345,6 +346,19 @@ static int display_connector_probe(struct platform_device *pdev)
}
}
+ /* enable DDC */
+ if (type == DRM_MODE_CONNECTOR_HDMIA) {
+ conn->ddc_en = devm_gpiod_get_optional(&pdev->dev, "ddc-en",
+ GPIOD_OUT_HIGH);
+
+ if (IS_ERR(conn->ddc_en)) {
+ dev_err(&pdev->dev, "Couldn't get ddc-en gpio\n");
+ return PTR_ERR(conn->ddc_en);
+ }
+
+ gpiod_set_value(conn->ddc_en, 1);
+ }
+
conn->bridge.funcs = &display_connector_bridge_funcs;
conn->bridge.of_node = pdev->dev.of_node;
@@ -373,6 +387,9 @@ static int display_connector_remove(struct platform_device *pdev)
{
struct display_connector *conn = platform_get_drvdata(pdev);
+ if (conn->ddc_en)
+ gpiod_set_value(conn->ddc_en, 0);
+
if (conn->dp_pwr)
regulator_disable(conn->dp_pwr);
"hdmi-connector.yaml" bindings defines an optional property "ddc-en-gpios" for a single gpio to enable DDC operation. Usually this controls +5V power on the HDMI connector. This +5V may also be needed for HPD. This was not reflected in code. Now, the driver activates the ddc gpio after probe and deactivates after remove so it is "almost on". But only if this driver is loaded (and not e.g. blacklisted as module). Signed-off-by: H. Nikolaus Schaller <hns@goldelico.com> --- drivers/gpu/drm/bridge/display-connector.c | 17 +++++++++++++++++ 1 file changed, 17 insertions(+)