@@ -114,6 +114,8 @@
rohm,touch-max-x = <384>;
rohm,touch-max-y = <704>;
rohm,flip-y;
+ pinctrl-names = "default";
+ pinctrl-0 = <&touch_rohm_mode>;
};
bu21013_tp@5d {
@@ -124,6 +126,8 @@
rohm,touch-max-x = <384>;
rohm,touch-max-y = <704>;
rohm,flip-y;
+ pinctrl-names = "default";
+ pinctrl-0 = <&touch_rohm_mode>;
};
};
@@ -166,6 +170,25 @@
};
};
};
+ touch {
+ touch_rohm_mode: touch_rohm {
+ /*
+ * ROHM touch screen uses GPIO 143 for
+ * RST1, GPIO 146 for RST2 and
+ * GPIO 67 for interrupts. Pull-up
+ * the IRQ line and drive both
+ * reset signals low.
+ */
+ stuib_cfg1 {
+ pins = "GPIO143_D12", "GPIO146_D13";
+ ste,config = <&gpio_out_lo>;
+ };
+ stuib_cfg2 {
+ pins = "GPIO67_G2";
+ ste,config = <&gpio_in_pu>;
+ };
+ };
+ };
};
};
};
@@ -43,7 +43,6 @@
<&vaudio_hf_hrefv60_mode>,
<&gbf_hrefv60_mode>,
<&hdtv_hrefv60_mode>,
- <&touch_hrefv60_mode>,
<&gpios_hrefv60_mode>;
sdi0 {
@@ -190,23 +189,6 @@
};
};
};
- touch {
- touch_hrefv60_mode: touch_hrefv60 {
- /*
- * Touch screen uses GPIO 143 for RST1, GPIO 146 for RST2 and
- * GPIO 67 for interrupts. Pull-up the IRQ line and drive both
- * reset signals low.
- */
- hrefv60_cfg1 {
- pins = "GPIO143_D12", "GPIO146_D13";
- ste,config = <&gpio_out_lo>;
- };
- hrefv60_cfg2 {
- pins = "GPIO67_G2";
- ste,config = <&gpio_in_pu>;
- };
- };
- };
mcde {
lcd_hrefv60_mode: lcd_hrefv60 {
/*
The Rohm touchscreen reset and IRQ lines were registered and configured at the HREF board level of the design, but it is an integral part of the UIB (User Interface Board). Fix this by pushing down the pin control node to the u8500 UIB file. Signed-off-by: Linus Walleij <linus.walleij@linaro.org> --- arch/arm/boot/dts/ste-href-stuib.dtsi | 23 +++++++++++++++++++++++ arch/arm/boot/dts/ste-hrefv60plus.dtsi | 18 ------------------ 2 files changed, 23 insertions(+), 18 deletions(-) -- 2.4.3 _______________________________________________ linux-arm-kernel mailing list linux-arm-kernel@lists.infradead.org http://lists.infradead.org/mailman/listinfo/linux-arm-kernel