| Message ID | 1449585124-15596-5-git-send-email-lee.jones@linaro.org |
|---|---|
| State | Superseded |
| Headers | show |
diff --git a/arch/arm/boot/dts/stih407-family.dtsi b/arch/arm/boot/dts/stih407-family.dtsi index 81f8121..9fa1e58 100644 --- a/arch/arm/boot/dts/stih407-family.dtsi +++ b/arch/arm/boot/dts/stih407-family.dtsi @@ -22,15 +22,29 @@ device_type = "cpu"; compatible = "arm,cortex-a9"; reg = <0>; + /* u-boot puts hpen in SBC dmem at 0xa4 offset */ cpu-release-addr = <0x94100A4>; + + /* kHz uV */ + operating-points = <1500000 0 + 1200000 0 + 800000 0 + 500000 0>; }; cpu@1 { device_type = "cpu"; compatible = "arm,cortex-a9"; reg = <1>; + /* u-boot puts hpen in SBC dmem at 0xa4 offset */ cpu-release-addr = <0x94100A4>; + + /* kHz uV */ + operating-points = <1500000 0 + 1200000 0 + 800000 0 + 500000 0>; }; };
You'll notice that the voltage cell is populated with 0's. Voltage information is very platform specific, even depends on 'cut' and 'substrate' versions. Thus it is left blank for a generic (safe) implementation. If other nodes/properties are provided by the bootloader, the ST CPUFreq driver will over-ride these generic values. Signed-off-by: Lee Jones <lee.jones@linaro.org> --- arch/arm/boot/dts/stih407-family.dtsi | 14 ++++++++++++++ 1 file changed, 14 insertions(+) -- 1.9.1 _______________________________________________ linux-arm-kernel mailing list linux-arm-kernel@lists.infradead.org http://lists.infradead.org/mailman/listinfo/linux-arm-kernel