@@ -10,6 +10,7 @@
#include <linux/gpio/driver.h>
#include <linux/interrupt.h>
#include <linux/io.h>
+#include <linux/mfd/ocelot.h>
#include <linux/of_device.h>
#include <linux/of_irq.h>
#include <linux/of_platform.h>
@@ -1917,7 +1918,6 @@ static int ocelot_pinctrl_probe(struct platform_device *pdev)
struct ocelot_pinctrl *info;
struct reset_control *reset;
struct regmap *pincfg;
- void __iomem *base;
int ret;
struct regmap_config regmap_config = {
.reg_bits = 32,
@@ -1937,16 +1937,12 @@ static int ocelot_pinctrl_probe(struct platform_device *pdev)
"Failed to get reset\n");
reset_control_reset(reset);
- base = devm_ioremap_resource(dev,
- platform_get_resource(pdev, IORESOURCE_MEM, 0));
- if (IS_ERR(base))
- return PTR_ERR(base);
-
info->stride = 1 + (info->desc->npins - 1) / 32;
regmap_config.max_register = OCELOT_GPIO_SD_MAP * info->stride + 15 * 4;
- info->map = devm_regmap_init_mmio(dev, base, ®map_config);
+ ocelot_platform_init_regmap_from_resource(pdev, 0, &info->map, NULL,
+ ®map_config);
if (IS_ERR(info->map)) {
dev_err(dev, "Failed to create regmap\n");
return PTR_ERR(info->map);
There are a few Ocelot chips that contain pinctrl logic, but can be controlled externally. Specifically the VSC7511, 7512, 7513 and 7514. In the externally controlled configurations these registers are not memory-mapped. Add support for these non-memory-mapped configurations. Signed-off-by: Colin Foster <colin.foster@in-advantage.com> --- drivers/pinctrl/pinctrl-ocelot.c | 10 +++------- 1 file changed, 3 insertions(+), 7 deletions(-)