| Message ID | 20220929011557.4165216-2-dmitry.torokhov@gmail.com |
|---|---|
| State | Accepted |
| Commit | 978bc4c578a6d7baffc5646b0f327da036b3051b |
| Headers | show |
| Series | None | expand |
diff --git a/arch/arm64/boot/dts/qcom/msm8916-samsung-a2015-common.dtsi b/arch/arm64/boot/dts/qcom/msm8916-samsung-a2015-common.dtsi index 3255bd3fcb55..5f7cec347a4f 100644 --- a/arch/arm64/boot/dts/qcom/msm8916-samsung-a2015-common.dtsi +++ b/arch/arm64/boot/dts/qcom/msm8916-samsung-a2015-common.dtsi @@ -144,7 +144,7 @@ nfc@27 { interrupt-parent = <&msmgpio>; interrupts = <21 IRQ_TYPE_EDGE_RISING>; - en-gpios = <&msmgpio 20 GPIO_ACTIVE_HIGH>; + en-gpios = <&msmgpio 20 GPIO_ACTIVE_LOW>; wake-gpios = <&msmgpio 49 GPIO_ACTIVE_HIGH>; clocks = <&rpmcc RPM_SMD_BB_CLK2_PIN>;
According to s3fwrn5 driver code the "enable" GPIO line is driven "high" when chip is not in use (mode is S3FWRN5_MODE_COLD), and is driven "low" when chip is in use. s3fwrn5_phy_power_ctrl(): ... gpio_set_value(phy->gpio_en, 1); ... if (mode != S3FWRN5_MODE_COLD) { msleep(S3FWRN5_EN_WAIT_TIME); gpio_set_value(phy->gpio_en, 0); msleep(S3FWRN5_EN_WAIT_TIME); } Therefore the line described by "en-gpios" property should be annotated as "active low". The wakeup gpio appears to have correct polarity (active high). Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com> --- arch/arm64/boot/dts/qcom/msm8916-samsung-a2015-common.dtsi | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)