@@ -248,7 +248,6 @@ struct sh_mmcif_host {
int sg_idx;
int sg_blkidx;
bool power;
- bool card_present;
bool ccs_enable; /* Command Completion Signal support */
bool clk_ctrl2_enable;
struct mutex thread_lock;
@@ -1091,42 +1090,30 @@ static void sh_mmcif_set_ios(struct mmc_host *mmc, struct mmc_ios *ios)
host->state = STATE_IOS;
spin_unlock_irqrestore(&host->lock, flags);
- if (ios->power_mode == MMC_POWER_UP) {
- if (!host->card_present) {
- /* See if we also get DMA */
+ switch (ios->power_mode) {
+ case MMC_POWER_UP:
+ sh_mmcif_set_power(host, ios);
+ if (!host->power) {
+ clk_prepare_enable(host->clk);
+ pm_runtime_get_sync(dev);
+ sh_mmcif_sync_reset(host);
sh_mmcif_request_dma(host);
- host->card_present = true;
+ host->power = true;
}
+ break;
+ case MMC_POWER_OFF:
sh_mmcif_set_power(host, ios);
- } else if (ios->power_mode == MMC_POWER_OFF || !ios->clock) {
- /* clock stop */
- sh_mmcif_clock_control(host, 0);
- if (ios->power_mode == MMC_POWER_OFF) {
- if (host->card_present) {
- sh_mmcif_release_dma(host);
- host->card_present = false;
- }
- }
if (host->power) {
- pm_runtime_put_sync(dev);
+ sh_mmcif_clock_control(host, 0);
+ sh_mmcif_release_dma(host);
+ pm_runtime_put(dev);
clk_disable_unprepare(host->clk);
host->power = false;
- if (ios->power_mode == MMC_POWER_OFF)
- sh_mmcif_set_power(host, ios);
- }
- host->state = STATE_IDLE;
- return;
- }
-
- if (ios->clock) {
- if (!host->power) {
- clk_prepare_enable(host->clk);
-
- pm_runtime_get_sync(dev);
- host->power = true;
- sh_mmcif_sync_reset(host);
}
+ break;
+ case MMC_POWER_ON:
sh_mmcif_clock_control(host, ios->clock);
+ break;
}
host->timing = ios->timing;
Both from a runtime PM and clock management point of view, the ->set_ios() code is unnecessary complex. A suboptimal path is also executed when the mmc core requests a clock rate of zero. As that happens during the card initialization phase, trying to save power by decreasing the runtime PM usage count and gating the clock via clk_disable_unprepare() is just superfluous. Moreover, from a runtime PM point of view the core will anyway keep the device active during the entire card initialization phase. Restructure the code to rely on the ios->power_mode to understand when the runtime PM usage count needs to be increased. Let's also deal with clock rate changes by simply applying the rate. Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org> --- drivers/mmc/host/sh_mmcif.c | 45 ++++++++++++++++----------------------------- 1 file changed, 16 insertions(+), 29 deletions(-) -- 1.9.1