@@ -147,9 +147,9 @@ static u32 i2c_dw_read_clear_intrbits_slave(struct dw_i2c_dev *dev)
* Interrupt service routine. This gets called whenever an I2C slave interrupt
* occurs.
*/
-
-static int i2c_dw_irq_handler_slave(struct dw_i2c_dev *dev)
+static irqreturn_t i2c_dw_isr_slave(int this_irq, void *dev_id)
{
+ struct dw_i2c_dev *dev = dev_id;
u32 raw_stat, stat, enabled, tmp;
u8 val = 0, slave_activity;
@@ -159,7 +159,7 @@ static int i2c_dw_irq_handler_slave(struct dw_i2c_dev *dev)
slave_activity = ((tmp & DW_IC_STATUS_SLAVE_ACTIVITY) >> 6);
if (!enabled || !(raw_stat & ~DW_IC_INTR_ACTIVITY) || !dev->slave)
- return 0;
+ return IRQ_NONE;
stat = i2c_dw_read_clear_intrbits_slave(dev);
dev_dbg(dev->dev,
@@ -205,17 +205,7 @@ static int i2c_dw_irq_handler_slave(struct dw_i2c_dev *dev)
if (stat & DW_IC_INTR_STOP_DET)
i2c_slave_event(dev->slave, I2C_SLAVE_STOP, &val);
- return 1;
-}
-
-static irqreturn_t i2c_dw_isr_slave(int this_irq, void *dev_id)
-{
- struct dw_i2c_dev *dev = dev_id;
- int ret;
-
- ret = i2c_dw_irq_handler_slave(dev);
-
- return IRQ_RETVAL(ret);
+ return IRQ_HANDLED;
}
static const struct i2c_algorithm i2c_dw_algo = {
Interrupt processing code in i2c-designware-slave.c is bit more readable if not divided into another subroutine. Also explicit IRQ_NONE and IRQ_HANDLED return values are more obvious. Signed-off-by: Jarkko Nikula <jarkko.nikula@linux.intel.com> --- drivers/i2c/busses/i2c-designware-slave.c | 18 ++++-------------- 1 file changed, 4 insertions(+), 14 deletions(-)