diff mbox series

pinconf-generic: fix style issues in pin_config_param doc

Message ID 20221117123542.1154252-1-niyas.sait@linaro.org
State Accepted
Commit c21dd79e9909c9cf90f8b1ca8ad2753cedb6c655
Headers show
Series pinconf-generic: fix style issues in pin_config_param doc | expand

Commit Message

Niyas Sait Nov. 17, 2022, 12:35 p.m. UTC 
Fixes following issues introduced in a  previous commit
to clarify values for pin config pull up and down types.

- replace spaces with tabs to be consistent with rest of the doc
- use capitalization for unit (ohms -> Ohms)

Signed-off-by: Niyas Sait <niyas.sait@linaro.org>
---
 include/linux/pinctrl/pinconf-generic.h | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

Comments

Linus Walleij Nov. 21, 2022, 1:38 p.m. UTC | #1 
On Thu, Nov 17, 2022 at 1:35 PM Niyas Sait <niyas.sait@linaro.org> wrote:

> Fixes following issues introduced in a  previous commit
> to clarify values for pin config pull up and down types.
>
> - replace spaces with tabs to be consistent with rest of the doc
> - use capitalization for unit (ohms -> Ohms)
>
> Signed-off-by: Niyas Sait <niyas.sait@linaro.org>

Patch applied!

Yours,
Linus Walleij
diff mbox series

Patch

diff --git a/include/linux/pinctrl/pinconf-generic.h b/include/linux/pinctrl/pinconf-generic.h
index 11e7394bcc70..537064a997a5 100644
--- a/include/linux/pinctrl/pinconf-generic.h
+++ b/include/linux/pinctrl/pinconf-generic.h
@@ -36,7 +36,7 @@  struct pinctrl_map;
  * @PIN_CONFIG_BIAS_PULL_DOWN: the pin will be pulled down (usually with high
  *	impedance to GROUND). If the argument is != 0 pull-down is enabled,
  *	the value is interpreted by the driver and can be custom or an SI unit
- *  such as ohms.
+ *  	such as Ohms.
  * @PIN_CONFIG_BIAS_PULL_PIN_DEFAULT: the pin will be pulled up or down based
  *	on embedded knowledge of the controller hardware, like current mux
  *	function. The pull direction and possibly strength too will normally
@@ -48,7 +48,7 @@  struct pinctrl_map;
  * @PIN_CONFIG_BIAS_PULL_UP: the pin will be pulled up (usually with high
  *	impedance to VDD). If the argument is != 0 pull-up is enabled,
  *	the value is interpreted by the driver and can be custom or an SI unit
- *  such as ohms.
+ *	such as Ohms.
  * @PIN_CONFIG_DRIVE_OPEN_DRAIN: the pin will be driven with open drain (open
  *	collector) which means it is usually wired with other output ports
  *	which are then pulled up with an external resistor. Setting this