diff mbox series

[2/2] wifi: ath11k: PMIC XO cal data support

Message ID 20221214121818.12928-3-quic_youghand@quicinc.com
State Superseded
Headers show
Series dt: bindings: add dt entry for XO calibration support | expand

Commit Message

Youghandhar Chintala Dec. 14, 2022, 12:18 p.m. UTC
PMIC XO is the clock source for Wi-Fi RF clock in integrated Wi-Fi
chipset ex: WCN6750. Due to board layout errors XO frequency drifts
can cause Wi-Fi RF clock inaccuracy.
XO calibration test tree in Factory Test Mode is used to find the
best frequency offset(for example +/-2 KHz )by programming XO trim
register. This ensure system clock stays within required 20 ppm
WLAN RF clock.

Retrieve the XO trim offset via system firmware (e.g., device tree),
especially in the case where the device doesn't have a useful EEPROM
on which to store the calibrated XO offset (e.g., for integrated Wi-Fi).
Calibrated XO offset is sent to firmware, which compensate the clock drift
by programing the XO trim register.

Tested-on: WCN6750 hw1.0 AHB WLAN.MSL.1.0.1-00887-QCAMSLSWPLZ-1

Signed-off-by: Youghandhar Chintala <quic_youghand@quicinc.com>
---
 drivers/net/wireless/ath/ath11k/ahb.c  |  8 ++++++++
 drivers/net/wireless/ath/ath11k/core.h |  3 +++
 drivers/net/wireless/ath/ath11k/qmi.c  | 24 ++++++++++++++++++++++++
 drivers/net/wireless/ath/ath11k/qmi.h  |  4 +++-
 4 files changed, 38 insertions(+), 1 deletion(-)
diff mbox series

Patch

diff --git a/drivers/net/wireless/ath/ath11k/ahb.c b/drivers/net/wireless/ath/ath11k/ahb.c
index d34a4d6325b2..89580b4e47a9 100644
--- a/drivers/net/wireless/ath/ath11k/ahb.c
+++ b/drivers/net/wireless/ath/ath11k/ahb.c
@@ -1039,6 +1039,14 @@  static int ath11k_ahb_fw_resources_init(struct ath11k_base *ab)
 	ab_ahb->fw.iommu_domain = iommu_dom;
 	of_node_put(node);
 
+	ret = of_property_read_u32(pdev->dev.of_node, "xo-cal-data", &ab->xo_cal_data);
+	if (ret) {
+		ath11k_dbg(ab, ATH11K_DBG_AHB, "failed to get xo-cal-data property\n");
+		return 0;
+	}
+	ab->xo_cal_supported = true;
+	ath11k_dbg(ab, ATH11K_DBG_AHB, "xo cal data 0x%x\n", ab->xo_cal_data);
+
 	return 0;
 
 err_iommu_unmap:
diff --git a/drivers/net/wireless/ath/ath11k/core.h b/drivers/net/wireless/ath/ath11k/core.h
index 22460b0abf03..783398e98915 100644
--- a/drivers/net/wireless/ath/ath11k/core.h
+++ b/drivers/net/wireless/ath/ath11k/core.h
@@ -969,6 +969,9 @@  struct ath11k_base {
 		const struct ath11k_pci_ops *ops;
 	} pci;
 
+	bool xo_cal_supported;
+	u32 xo_cal_data;
+
 	/* must be last */
 	u8 drv_priv[] __aligned(sizeof(void *));
 };
diff --git a/drivers/net/wireless/ath/ath11k/qmi.c b/drivers/net/wireless/ath/ath11k/qmi.c
index 145f20a681bd..67f386b001ab 100644
--- a/drivers/net/wireless/ath/ath11k/qmi.c
+++ b/drivers/net/wireless/ath/ath11k/qmi.c
@@ -1451,6 +1451,24 @@  static struct qmi_elem_info qmi_wlanfw_wlan_mode_req_msg_v01_ei[] = {
 		.offset		= offsetof(struct qmi_wlanfw_wlan_mode_req_msg_v01,
 					   hw_debug),
 	},
+	{
+		.data_type  = QMI_OPT_FLAG,
+		.elem_len   = 1,
+		.elem_size  = sizeof(u8),
+		.array_type = NO_ARRAY,
+		.tlv_type   = 0x11,
+		.offset     = offsetof(struct qmi_wlanfw_wlan_mode_req_msg_v01,
+				       xo_cal_data_valid),
+	},
+	{
+		.data_type  = QMI_UNSIGNED_1_BYTE,
+		.elem_len   = 1,
+		.elem_size  = sizeof(u8),
+		.array_type = NO_ARRAY,
+		.tlv_type   = 0x11,
+		.offset     = offsetof(struct qmi_wlanfw_wlan_mode_req_msg_v01,
+				       xo_cal_data),
+	},
 	{
 		.data_type	= QMI_EOTI,
 		.array_type	= NO_ARRAY,
@@ -2610,6 +2628,12 @@  static int ath11k_qmi_wlanfw_mode_send(struct ath11k_base *ab,
 	req.hw_debug_valid = 1;
 	req.hw_debug = 0;
 
+	if (ab->xo_cal_supported) {
+		req.xo_cal_data_valid = 1;
+		req.xo_cal_data = ab->xo_cal_data;
+	}
+	ath11k_dbg(ab, ATH11K_DBG_QMI, "xo_cal_supported %d\n", ab->xo_cal_supported);
+
 	ret = qmi_txn_init(&ab->qmi.handle, &txn,
 			   qmi_wlanfw_wlan_mode_resp_msg_v01_ei, &resp);
 	if (ret < 0)
diff --git a/drivers/net/wireless/ath/ath11k/qmi.h b/drivers/net/wireless/ath/ath11k/qmi.h
index 2ec56a34fa81..db61ce0d5689 100644
--- a/drivers/net/wireless/ath/ath11k/qmi.h
+++ b/drivers/net/wireless/ath/ath11k/qmi.h
@@ -450,7 +450,7 @@  struct qmi_wlanfw_m3_info_resp_msg_v01 {
 	struct qmi_response_type_v01 resp;
 };
 
-#define QMI_WLANFW_WLAN_MODE_REQ_MSG_V01_MAX_LEN	11
+#define QMI_WLANFW_WLAN_MODE_REQ_MSG_V01_MAX_LEN	17
 #define QMI_WLANFW_WLAN_MODE_RESP_MSG_V01_MAX_LEN	7
 #define QMI_WLANFW_WLAN_CFG_REQ_MSG_V01_MAX_LEN		803
 #define QMI_WLANFW_WLAN_CFG_RESP_MSG_V01_MAX_LEN	7
@@ -470,6 +470,8 @@  struct qmi_wlanfw_wlan_mode_req_msg_v01 {
 	u32 mode;
 	u8 hw_debug_valid;
 	u8 hw_debug;
+	u8 xo_cal_data_valid;
+	u8 xo_cal_data;
 };
 
 struct qmi_wlanfw_wlan_mode_resp_msg_v01 {