@@ -11,7 +11,9 @@
#include <linux/kernel.h>
#include <linux/module.h>
#include <linux/of.h>
+#include <linux/of_device.h>
#include <linux/platform_device.h>
+#include <linux/qcom_scm.h>
#include <linux/slab.h>
#include <linux/sysfs.h>
#include <linux/usb/role.h>
@@ -30,15 +32,24 @@
#define EUD_INT_SAFE_MODE BIT(4)
#define EUD_INT_ALL (EUD_INT_VBUS | EUD_INT_SAFE_MODE)
+struct eud_soc_data {
+ bool secure_eud_en;
+ bool tcsr_check_enable;
+};
+
struct eud_chip {
struct device *dev;
struct usb_role_switch *role_sw;
+ const struct eud_soc_data *eud_data;
void __iomem *base;
void __iomem *mode_mgr;
unsigned int int_status;
int irq;
bool enabled;
bool usb_attached;
+ phys_addr_t mode_mgr_phys_base;
+ phys_addr_t tcsr_check_phys_base;
+
};
static int enable_eud(struct eud_chip *priv)
@@ -46,7 +57,11 @@ static int enable_eud(struct eud_chip *priv)
writel(EUD_ENABLE, priv->base + EUD_REG_CSR_EUD_EN);
writel(EUD_INT_VBUS | EUD_INT_SAFE_MODE,
priv->base + EUD_REG_INT1_EN_MASK);
- writel(1, priv->mode_mgr + EUD_REG_EUD_EN2);
+
+ if (priv->eud_data->secure_eud_en)
+ qcom_scm_io_writel(priv->mode_mgr_phys_base + EUD_REG_EUD_EN2, BIT(0));
+ else
+ writel(1, priv->mode_mgr + EUD_REG_EUD_EN2);
return usb_role_switch_set_role(priv->role_sw, USB_ROLE_DEVICE);
}
@@ -54,7 +69,11 @@ static int enable_eud(struct eud_chip *priv)
static void disable_eud(struct eud_chip *priv)
{
writel(0, priv->base + EUD_REG_CSR_EUD_EN);
- writel(0, priv->mode_mgr + EUD_REG_EUD_EN2);
+
+ if (priv->eud_data->secure_eud_en)
+ qcom_scm_io_writel(priv->mode_mgr_phys_base + EUD_REG_EUD_EN2, 0);
+ else
+ writel(0, priv->mode_mgr + EUD_REG_EUD_EN2);
}
static ssize_t enable_show(struct device *dev,
@@ -178,12 +197,15 @@ static void eud_role_switch_release(void *data)
static int eud_probe(struct platform_device *pdev)
{
struct eud_chip *chip;
+ struct resource *res;
int ret;
chip = devm_kzalloc(&pdev->dev, sizeof(*chip), GFP_KERNEL);
if (!chip)
return -ENOMEM;
+ chip->eud_data = of_device_get_match_data(&pdev->dev);
+
chip->dev = &pdev->dev;
chip->role_sw = usb_role_switch_get(&pdev->dev);
@@ -200,10 +222,25 @@ static int eud_probe(struct platform_device *pdev)
if (IS_ERR(chip->base))
return PTR_ERR(chip->base);
- chip->mode_mgr = devm_platform_ioremap_resource(pdev, 1);
+ chip->mode_mgr = devm_platform_get_and_ioremap_resource(pdev, 1, &res);
if (IS_ERR(chip->mode_mgr))
return PTR_ERR(chip->mode_mgr);
+ if (chip->eud_data->secure_eud_en)
+ chip->mode_mgr_phys_base = res->start;
+
+ if (chip->eud_data->tcsr_check_enable) {
+ res = platform_get_resource(pdev, IORESOURCE_MEM, 2);
+ if (!res)
+ return dev_err_probe(chip->dev, -ENODEV, "failed to get tcsr reg base\n");
+
+ chip->tcsr_check_phys_base = res->start;
+
+ ret = qcom_scm_io_writel(chip->tcsr_check_phys_base, BIT(0));
+ if (ret)
+ return dev_err_probe(chip->dev, ret, "failed to write tcsr check reg\n");
+ }
+
chip->irq = platform_get_irq(pdev, 0);
ret = devm_request_threaded_irq(&pdev->dev, chip->irq, handle_eud_irq,
handle_eud_irq_thread, IRQF_ONESHOT, NULL, chip);
@@ -230,8 +267,14 @@ static int eud_remove(struct platform_device *pdev)
return 0;
}
+static const struct eud_soc_data sm6115_eud_data = {
+ .secure_eud_en = true,
+ .tcsr_check_enable = true,
+};
+
static const struct of_device_id eud_dt_match[] = {
{ .compatible = "qcom,sc7280-eud" },
+ { .compatible = "qcom,sm6115-eud", .data = &sm6115_eud_data },
{ }
};
MODULE_DEVICE_TABLE(of, eud_dt_match);
Add SM6115 / SM4250 SoC EUD support in qcom_eud driver. On some SoCs (like the SM6115 / SM4250 SoC), the mode manager needs to be accessed only via the secure world (through 'scm' calls). Also, the enable bit inside 'tcsr_check_reg' needs to be set first to set the eud in 'enable' mode on these SoCs. Cc: Souradeep Chowdhury <quic_schowdhu@quicinc.com> Signed-off-by: Bhupesh Sharma <bhupesh.sharma@linaro.org> --- drivers/usb/misc/qcom_eud.c | 49 ++++++++++++++++++++++++++++++++++--- 1 file changed, 46 insertions(+), 3 deletions(-)