| Message ID | 20230324021651.1799969-2-dmitry.baryshkov@linaro.org |
|---|---|
| State | Accepted |
| Commit | 1dc40551f206d20b7e46ea7dd538dcdd928451c6 |
| Headers | show |
| Series | [1/2] arm64: dts: qcom: ipq8074-hk01: enable QMP device, not the PHY node | expand |
diff --git a/arch/arm64/boot/dts/qcom/ipq8074-hk10.dtsi b/arch/arm64/boot/dts/qcom/ipq8074-hk10.dtsi index 651a231554e0..1b8379ba87f9 100644 --- a/arch/arm64/boot/dts/qcom/ipq8074-hk10.dtsi +++ b/arch/arm64/boot/dts/qcom/ipq8074-hk10.dtsi @@ -48,11 +48,11 @@ &pcie1 { perst-gpios = <&tlmm 61 GPIO_ACTIVE_LOW>; }; -&pcie_phy0 { +&pcie_qmp0 { status = "okay"; }; -&pcie_phy1 { +&pcie_qmp1 { status = "okay"; };
Correct PCIe PHY enablement to refer the QMP device nodes rather than PHY device nodes. QMP nodes have 'status = "disabled"' property in the ipq8074.dtsi, while PHY nodes do not correspond to the actual device and do not have the status property. Fixes: 1ed34da63a37 ("arm64: dts: qcom: Add board support for HK10") Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org> --- arch/arm64/boot/dts/qcom/ipq8074-hk10.dtsi | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)