| Message ID | 20230324021651.1799969-1-dmitry.baryshkov@linaro.org |
|---|---|
| State | Accepted |
| Commit | 72630ba422b70ea0874fc90d526353cf71c72488 |
| Headers | show |
| Series | [1/2] arm64: dts: qcom: ipq8074-hk01: enable QMP device, not the PHY node | expand |
diff --git a/arch/arm64/boot/dts/qcom/ipq8074-hk01.dts b/arch/arm64/boot/dts/qcom/ipq8074-hk01.dts index ca3f96646b90..5cf07caf4103 100644 --- a/arch/arm64/boot/dts/qcom/ipq8074-hk01.dts +++ b/arch/arm64/boot/dts/qcom/ipq8074-hk01.dts @@ -62,11 +62,11 @@ &pcie1 { perst-gpios = <&tlmm 58 GPIO_ACTIVE_LOW>; }; -&pcie_phy0 { +&pcie_qmp0 { status = "okay"; }; -&pcie_phy1 { +&pcie_qmp1 { status = "okay"; };
Correct PCIe PHY enablement to refer the QMP device nodes rather than PHY device nodes. QMP nodes have 'status = "disabled"' property in the ipq8074.dtsi, while PHY nodes do not correspond to the actual device and do not have the status property. Fixes: e8a7fdc505bb ("arm64: dts: ipq8074: qcom: Re-arrange dts nodes based on address") Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org> --- arch/arm64/boot/dts/qcom/ipq8074-hk01.dts | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)