@@ -328,6 +328,25 @@ memory@80000000 {
reg = <0x0 0x80000000 0x0 0x0>;
};
+ dsi_opp_table: opp-table-dsi {
+ compatible = "operating-points-v2";
+
+ opp-131250000 {
+ opp-hz = /bits/ 64 <131250000>;
+ required-opps = <&rpmpd_opp_svs>;
+ };
+
+ opp-210000000 {
+ opp-hz = /bits/ 64 <210000000>;
+ required-opps = <&rpmpd_opp_svs_plus>;
+ };
+
+ opp-262500000 {
+ opp-hz = /bits/ 64 <262500000>;
+ required-opps = <&rpmpd_opp_nom>;
+ };
+ };
+
pmu {
compatible = "arm,armv8-pmuv3";
interrupts = <GIC_PPI 6 IRQ_TYPE_LEVEL_HIGH>;
@@ -1591,25 +1610,6 @@ dsi0: dsi@c994000 {
status = "disabled";
- dsi_opp_table: opp-table {
- compatible = "operating-points-v2";
-
- opp-131250000 {
- opp-hz = /bits/ 64 <131250000>;
- required-opps = <&rpmpd_opp_svs>;
- };
-
- opp-210000000 {
- opp-hz = /bits/ 64 <210000000>;
- required-opps = <&rpmpd_opp_svs_plus>;
- };
-
- opp-262500000 {
- opp-hz = /bits/ 64 <262500000>;
- required-opps = <&rpmpd_opp_nom>;
- };
- };
-
ports {
#address-cells = <1>;
#size-cells = <0>;
The DSI OPP table on SDM630 is used by one DSI0, but on SDM660 is shared by two nodes (DSI0 and DSI1), thus it should be rather in top-level, not in DSI0. Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org> --- A cleanup patch to commit a2e5260d0755 ("arm64: dts: qcom: sdm630: move DSI opp-table into DSI node"). Follow-up to: https://lore.kernel.org/all/20230407163442.ckbd4vxa5b2xu3eu@ripper/ --- arch/arm64/boot/dts/qcom/sdm630.dtsi | 38 ++++++++++++++-------------- 1 file changed, 19 insertions(+), 19 deletions(-)