@@ -2914,6 +2914,7 @@ static const struct of_device_id scmi_of_match[] = {
#endif
#ifdef CONFIG_ARM_SCMI_TRANSPORT_SMC
{ .compatible = "arm,scmi-smc", .data = &scmi_smc_desc},
+ { .compatible = "arm,scmi-smc-param", .data = &scmi_smc_desc},
#endif
#ifdef CONFIG_ARM_SCMI_TRANSPORT_VIRTIO
{ .compatible = "arm,scmi-virtio", .data = &scmi_virtio_desc},
@@ -20,6 +20,9 @@
#include "common.h"
+#define lower32(x) ((u32)((x) & 0xffffffff))
+#define upper32(x) ((u32)(((u64)(x) >> 32) & 0xffffffff))
+
/**
* struct scmi_smc - Structure representing a SCMI smc transport
*
@@ -30,6 +33,8 @@
* @inflight: Atomic flag to protect access to Tx/Rx shared memory area.
* Used when operating in atomic mode.
* @func_id: smc/hvc call function id
+ * @is_smc64: smc/hvc calling convention type 64 vs 32
+ * @param: physical address of the shmem channel
*/
struct scmi_smc {
@@ -40,6 +45,8 @@ struct scmi_smc {
#define INFLIGHT_NONE MSG_TOKEN_MAX
atomic_t inflight;
u32 func_id;
+ bool is_smc64;
+ phys_addr_t param;
};
static irqreturn_t smc_msg_done_isr(int irq, void *data)
@@ -137,6 +144,8 @@ static int smc_chan_setup(struct scmi_chan_info *cinfo, struct device *dev,
if (ret < 0)
return ret;
+ if (of_device_is_compatible(dev->of_node, "arm,scmi-smc-param"))
+ scmi_info->param = res.start;
/*
* If there is an interrupt named "a2p", then the service and
* completion of a message is signaled by an interrupt rather than by
@@ -156,6 +165,7 @@ static int smc_chan_setup(struct scmi_chan_info *cinfo, struct device *dev,
}
scmi_info->func_id = func_id;
+ scmi_info->is_smc64 = ARM_SMCCC_IS_64(func_id);
scmi_info->cinfo = cinfo;
smc_channel_lock_init(scmi_info);
cinfo->transport_info = scmi_info;
@@ -188,7 +198,20 @@ static int smc_send_message(struct scmi_chan_info *cinfo,
shmem_tx_prepare(scmi_info->shmem, xfer, cinfo);
- arm_smccc_1_1_invoke(scmi_info->func_id, 0, 0, 0, 0, 0, 0, 0, &res);
+#ifdef CONFIG_ARM64
+ /*
+ * if SMC32 convention is used, pass 64 bit address in
+ * two parameters
+ */
+ if (!scmi_info->is_smc64)
+ arm_smccc_1_1_invoke(scmi_info->func_id,
+ lower32(scmi_info->param),
+ upper32(scmi_info->param),
+ 0, 0, 0, 0, 0, &res);
+ else
+#endif
+ arm_smccc_1_1_invoke(scmi_info->func_id, scmi_info->param,
+ 0, 0, 0, 0, 0, 0, &res);
/* Only SMCCC_RET_NOT_SUPPORTED is valid error code */
if (res.a0) {
This patch add support for passing shmem channel address as parameter in smc/hvc call. This patch is useful when multiple scmi instances are using same smc-id and firmware needs to distiguish among the instances. Signed-off-by: Nikunj Kela <quic_nkela@quicinc.com> --- drivers/firmware/arm_scmi/driver.c | 1 + drivers/firmware/arm_scmi/smc.c | 25 ++++++++++++++++++++++++- 2 files changed, 25 insertions(+), 1 deletion(-)