@@ -226,46 +226,6 @@ smem {
hwlocks = <&sfpb_mutex 3>;
};
- smd {
- compatible = "qcom,smd";
-
- modem-edge {
- interrupts = <0 37 IRQ_TYPE_EDGE_RISING>;
-
- qcom,ipc = <&l2cc 8 3>;
- qcom,smd-edge = <0>;
-
- status = "disabled";
- };
-
- q6-edge {
- interrupts = <0 90 IRQ_TYPE_EDGE_RISING>;
-
- qcom,ipc = <&l2cc 8 15>;
- qcom,smd-edge = <1>;
-
- status = "disabled";
- };
-
- dsps-edge {
- interrupts = <0 138 IRQ_TYPE_EDGE_RISING>;
-
- qcom,ipc = <&sps_sic_non_secure 0x4080 0>;
- qcom,smd-edge = <3>;
-
- status = "disabled";
- };
-
- riva-edge {
- interrupts = <0 198 IRQ_TYPE_EDGE_RISING>;
-
- qcom,ipc = <&l2cc 8 25>;
- qcom,smd-edge = <6>;
-
- status = "disabled";
- };
- };
-
smsm {
compatible = "qcom,smsm";
The "smd-edge"s for remote processors are typically specified below the remoteproc nodes. For some reason apq8064 also has them all listed in a top-level /smd node, disabled by default. None of the boards enable them. Right now apq8064 only has support for WCNSS/riva, but there the smd-edge is already defined with the same interrupt etc below the riva-pil node. Drop these redundant definitions since the /smd top-level node is now deprecated. Signed-off-by: Stephan Gerhold <stephan@gerhold.net> --- arch/arm/boot/dts/qcom-apq8064.dtsi | 40 ------------------------------------- 1 file changed, 40 deletions(-)