@@ -339,7 +339,25 @@ static int rt5682_sdw_init(struct device *dev, struct regmap *regmap,
ret = devm_snd_soc_register_component(dev,
&rt5682_soc_component_dev,
rt5682_dai, ARRAY_SIZE(rt5682_dai));
- dev_dbg(&slave->dev, "%s\n", __func__);
+ if (ret < 0)
+ return ret;
+
+ /* set autosuspend parameters */
+ pm_runtime_set_autosuspend_delay(dev, 3000);
+ pm_runtime_use_autosuspend(dev);
+
+ /* make sure the device does not suspend immediately */
+ pm_runtime_mark_last_busy(dev);
+
+ pm_runtime_enable(dev);
+
+ /* important note: the device is NOT tagged as 'active' and will remain
+ * 'suspended' until the hardware is enumerated/initialized. This is required
+ * to make sure the ASoC framework use of pm_runtime_get_sync() does not silently
+ * fail with -EACCESS because of race conditions between card creation and enumeration
+ */
+
+ dev_dbg(dev, "%s\n", __func__);
return ret;
}
@@ -361,22 +379,12 @@ static int rt5682_io_init(struct device *dev, struct sdw_slave *slave)
regcache_cache_bypass(rt5682->regmap, true);
/*
- * PM runtime is only enabled when a Slave reports as Attached
+ * PM runtime status is marked as 'active' only when a Slave reports as Attached
*/
- if (!rt5682->first_hw_init) {
- /* set autosuspend parameters */
- pm_runtime_set_autosuspend_delay(&slave->dev, 3000);
- pm_runtime_use_autosuspend(&slave->dev);
-
+ if (!rt5682->first_hw_init)
/* update count of parent 'active' children */
pm_runtime_set_active(&slave->dev);
- /* make sure the device does not suspend immediately */
- pm_runtime_mark_last_busy(&slave->dev);
-
- pm_runtime_enable(&slave->dev);
- }
-
pm_runtime_get_noresume(&slave->dev);
while (loop > 0) {
@@ -687,8 +695,7 @@ static int rt5682_sdw_remove(struct sdw_slave *slave)
if (rt5682->hw_init)
cancel_delayed_work_sync(&rt5682->jack_detect_work);
- if (rt5682->first_hw_init)
- pm_runtime_disable(&slave->dev);
+ pm_runtime_disable(&slave->dev);
return 0;
}
@@ -1017,6 +1017,9 @@ static int rt5682_set_jack_detect(struct snd_soc_component *component,
rt5682->hs_jack = hs_jack;
+ if (rt5682->is_sdw && !rt5682->first_hw_init)
+ return 0;
+
if (!hs_jack) {
regmap_update_bits(rt5682->regmap, RT5682_IRQ_CTRL_2,
RT5682_JD1_EN_MASK, RT5682_JD1_DIS);