@@ -193,10 +193,7 @@ static int rt715_sdca_sdw_probe(struct sdw_slave *slave,
static int rt715_sdca_sdw_remove(struct sdw_slave *slave)
{
- struct rt715_sdca_priv *rt715 = dev_get_drvdata(&slave->dev);
-
- if (rt715->first_hw_init)
- pm_runtime_disable(&slave->dev);
+ pm_runtime_disable(&slave->dev);
return 0;
}
@@ -761,8 +761,12 @@ static const struct snd_soc_dapm_route rt715_sdca_audio_map[] = {
static int rt715_sdca_probe(struct snd_soc_component *component)
{
+ struct rt715_sdca_priv *rt715 = snd_soc_component_get_drvdata(component);
int ret;
+ if (!rt715->first_hw_init)
+ return 0;
+
ret = pm_runtime_resume(component->dev);
if (ret < 0 && ret != -EACCES)
return ret;
@@ -992,6 +996,25 @@ int rt715_sdca_init(struct device *dev, struct regmap *mbq_regmap,
&soc_codec_dev_rt715_sdca,
rt715_sdca_dai,
ARRAY_SIZE(rt715_sdca_dai));
+ if (ret < 0)
+ return ret;
+
+ /* set autosuspend parameters */
+ pm_runtime_set_autosuspend_delay(dev, 3000);
+ pm_runtime_use_autosuspend(dev);
+
+ /* make sure the device does not suspend immediately */
+ pm_runtime_mark_last_busy(dev);
+
+ pm_runtime_enable(dev);
+
+ /* important note: the device is NOT tagged as 'active' and will remain
+ * 'suspended' until the hardware is enumerated/initialized. This is required
+ * to make sure the ASoC framework use of pm_runtime_get_sync() does not silently
+ * fail with -EACCESS because of race conditions between card creation and enumeration
+ */
+
+ dev_dbg(dev, "%s\n", __func__);
return ret;
}
@@ -1008,21 +1031,12 @@ int rt715_sdca_io_init(struct device *dev, struct sdw_slave *slave)
regcache_cache_only(rt715->mbq_regmap, false);
/*
- * PM runtime is only enabled when a Slave reports as Attached
+ * PM runtime status is marked as 'active' only when a Slave reports as Attached
*/
if (!rt715->first_hw_init) {
- /* set autosuspend parameters */
- pm_runtime_set_autosuspend_delay(&slave->dev, 3000);
- pm_runtime_use_autosuspend(&slave->dev);
-
/* update count of parent 'active' children */
pm_runtime_set_active(&slave->dev);
- /* make sure the device does not suspend immediately */
- pm_runtime_mark_last_busy(&slave->dev);
-
- pm_runtime_enable(&slave->dev);
-
rt715->first_hw_init = true;
}