@@ -7,6 +7,15 @@
#include <dt-bindings/interrupt-controller/irq.h>
#include <dt-bindings/spmi/spmi.h>
+/* This PMIC can be configured to be at different SIDs */
+#ifndef PM7250B_SID
+ #define PM7250B_SID 2
+#endif
+
+#ifndef PM7250B_SID1
+ #define PM7250B_SID1 3
+#endif
+
/ {
thermal-zones {
pm7250b-thermal {
@@ -39,16 +48,16 @@ trip2 {
};
&spmi_bus {
- pmic@2 {
+ pmic@PM7250B_SID {
compatible = "qcom,pm7250b", "qcom,spmi-pmic";
- reg = <0x2 SPMI_USID>;
+ reg = <PM7250B_SID SPMI_USID>;
#address-cells = <1>;
#size-cells = <0>;
pm7250b_temp: temp-alarm@2400 {
compatible = "qcom,spmi-temp-alarm";
reg = <0x2400>;
- interrupts = <0x2 0x24 0x0 IRQ_TYPE_EDGE_BOTH>;
+ interrupts = <PM7250B_SID 0x24 0x0 IRQ_TYPE_EDGE_BOTH>;
io-channels = <&pm7250b_adc ADC5_DIE_TEMP>;
io-channel-names = "thermal";
#thermal-sensor-cells = <0>;
@@ -60,7 +69,7 @@ pm7250b_adc: adc@3100 {
#address-cells = <1>;
#size-cells = <0>;
#io-channel-cells = <1>;
- interrupts = <0x2 0x31 0x0 IRQ_TYPE_EDGE_RISING>;
+ interrupts = <PM7250B_SID 0x31 0x0 IRQ_TYPE_EDGE_RISING>;
channel@0 {
reg = <ADC5_REF_GND>;
@@ -141,7 +150,7 @@ channel@99 {
pm7250b_adc_tm: adc-tm@3500 {
compatible = "qcom,spmi-adc-tm5";
reg = <0x3500>;
- interrupts = <0x2 0x35 0x0 IRQ_TYPE_EDGE_RISING>;
+ interrupts = <PM7250B_SID 0x35 0x0 IRQ_TYPE_EDGE_RISING>;
#thermal-sensor-cells = <1>;
#address-cells = <1>;
#size-cells = <0>;
@@ -159,9 +168,9 @@ pm7250b_gpios: pinctrl@c000 {
};
};
- pmic@3 {
+ pmic@PM7250B_SID1 {
compatible = "qcom,pm7250b", "qcom,spmi-pmic";
- reg = <0x3 SPMI_USID>;
+ reg = <PM7250B_SID1 SPMI_USID>;
#address-cells = <1>;
#size-cells = <0>;
};
Like other Qualcomm PMICs the PM7250B can be used on different addresses on the SPMI bus. Use similar defines like the PMK8350 to make this possible. Signed-off-by: Luca Weiss <luca.weiss@fairphone.com> --- arch/arm64/boot/dts/qcom/pm7250b.dtsi | 23 ++++++++++++++++------- 1 file changed, 16 insertions(+), 7 deletions(-)