@@ -352,7 +352,19 @@ static void __csid_configure_stream(struct csid_device *csid, u8 enable, u8 vc)
phy_sel = csid->phy.csiphy_id;
if (enable) {
- u8 dt_id = vc;
+ /*
+ * DT_ID is a two bit bitfield that is concatenated with
+ * the four least significant bits of the five bit VC
+ * bitfield to generate an internal CID value.
+ *
+ * CSID_RDI_CFG0(vc)
+ * DT_ID : 28:27
+ * VC : 26:22
+ * DT : 21:16
+ *
+ * CID : VC 3:0 << 2 | DT_ID 1:0
+ */
+ u8 dt_id = vc & 0x03;
if (tg->enabled) {
/* configure one DT, infinite frames */
Digging into the documentation we find that the DT_ID bitfield is used to map the six bit DT to a two bit ID code. This value is concatenated to the VC bitfield to create a CID value. DT_ID is the two least significant bits of CID and VC the most significant bits. Originally we set dt_id = vc * 4 in and then subsequently set dt_id = vc. commit 3c4ed72a16bc ("media: camss: sm8250: Virtual channels for CSID") silently fixed the multiplication by four which would give a better value for the generated CID without mentioning what was being done or why. Next up I haplessly changed the value back to "dt_id = vc * 4" since there didn't appear to be any logic behind it. Hans asked what the change was for and I honestly couldn't remember the provenance of it, so I dug in. Link: https://lore.kernel.org/linux-arm-msm/edd4bf9b-0e1b-883c-1a4d-50f4102c3924@xs4all.nl/ Add a comment so the next hapless programmer doesn't make this same mistake. Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@linaro.org> --- .../media/platform/qcom/camss/camss-csid-gen2.c | 14 +++++++++++++- 1 file changed, 13 insertions(+), 1 deletion(-)