@@ -3,6 +3,8 @@
/dts-v1/;
#include "msm8916-pm8916.dtsi"
+#include "msm8916-modem-qdsp6.dtsi"
+
#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/input/input.h>
#include <dt-bindings/interrupt-controller/irq.h>
@@ -25,17 +27,26 @@ chosen {
/*
* For some reason, the signed wcnss firmware is not relocatable.
- * It must be loaded at 0x8b600000. All other firmware is relocatable,
- * so place wcnss at the fixed address and then all other firmware
- * regions will be automatically allocated at a fitting place.
+ * It must be loaded at 0x8b600000. Unfortunately, this also means that
+ * mpss_mem does not fit when loaded to the typical address at 0x86800000.
+ *
+ * Load wcnss_mem to the fixed address and relocate mpss_mem to the next
+ * working higher address. For some reason the modem firmware does not
+ * boot when placed at 0x8a800000 to 0x8e800000.
*/
reserved-memory {
+ /delete-node/ mpss@86800000;
/delete-node/ wcnss;
wcnss_mem: wcnss@8b600000 {
reg = <0x0 0x8b600000 0x0 0x600000>;
no-map;
};
+
+ mpss_mem: mpss@8e800000 {
+ reg = <0x0 0x8e800000 0x0 0x5000000>;
+ no-map;
+ };
};
gpio-keys {
@@ -225,6 +236,13 @@ &blsp_uart2 {
status = "okay";
};
+&pm8916_codec {
+ qcom,micbias-lvl = <2800>;
+ qcom,mbhc-vthreshold-low = <75 150 237 450 500>;
+ qcom,mbhc-vthreshold-high = <75 150 237 450 500>;
+ qcom,hphl-jack-type-normally-open;
+};
+
&pm8916_resin {
status = "okay";
linux,code = <KEY_VOLUMEDOWN>;
@@ -254,6 +272,13 @@ &sdhc_2 {
non-removable;
};
+&sound {
+ audio-routing =
+ "AMIC1", "MIC BIAS Internal1",
+ "AMIC2", "MIC BIAS Internal2",
+ "AMIC3", "MIC BIAS Internal3";
+};
+
&usb {
status = "okay";
dr_mode = "peripheral";