@@ -1183,22 +1183,10 @@ spi0: spi@1100a000 {
status = "disabled";
};
- svs: svs@1100b000 {
- compatible = "mediatek,mt8183-svs";
- reg = <0 0x1100b000 0 0x1000>;
- interrupts = <GIC_SPI 127 IRQ_TYPE_LEVEL_LOW>;
- clocks = <&infracfg CLK_INFRA_THERM>;
- clock-names = "main";
- nvmem-cells = <&svs_calibration>,
- <&thermal_calibration>;
- nvmem-cell-names = "svs-calibration-data",
- "t-calibration-data";
- };
-
thermal: thermal@1100b000 {
#thermal-sensor-cells = <1>;
compatible = "mediatek,mt8183-thermal";
- reg = <0 0x1100b000 0 0x1000>;
+ reg = <0 0x1100b000 0 0xc00>;
clocks = <&infracfg CLK_INFRA_THERM>,
<&infracfg CLK_INFRA_AUXADC>;
clock-names = "therm", "auxadc";
@@ -1210,6 +1198,18 @@ thermal: thermal@1100b000 {
nvmem-cell-names = "calibration-data";
};
+ svs: svs@1100bc00 {
+ compatible = "mediatek,mt8183-svs";
+ reg = <0 0x1100bc00 0 0x400>;
+ interrupts = <GIC_SPI 127 IRQ_TYPE_LEVEL_LOW>;
+ clocks = <&infracfg CLK_INFRA_THERM>;
+ clock-names = "main";
+ nvmem-cells = <&svs_calibration>,
+ <&thermal_calibration>;
+ nvmem-cell-names = "svs-calibration-data",
+ "t-calibration-data";
+ };
+
thermal_zones: thermal-zones {
cpu_thermal: cpu-thermal {
polling-delay-passive = <100>;
The SVS iospace starts at 0x1100bc00 and not at 0x1100b000 as the latter is the thermal sensor iospace instead. Change the iospaces for both as following: - Thermal: 0x1100b000, length 0xc00 - SVS: 0x1100bc00, length 0x400 Please note that while this would be a breaking change for SVS (but not for thermal sensors), it doesn't matter because the svs driver never worked anyway because of the missing trips in tzts2, causing that thermal zone to never actually register, hence the SVS driver to fail probing anyway. Signed-off-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@collabora.com> --- arch/arm64/boot/dts/mediatek/mt8183.dtsi | 26 ++++++++++++------------ 1 file changed, 13 insertions(+), 13 deletions(-)