@@ -38,6 +38,11 @@ to deliver its interrupts via SPIs.
architecturally-defined reset values. Only supported for 32-bit
systems which follow the ARMv7 architected reset values.
+- arm,no-tick-in-suspend : The main counter does not tick when the system is in
+ low-power system suspend on some SoCs. This behavior does not match the
+ Architecture Reference Manual's specification that the system counter "must
+ be implemented in an always-on power domain."
+
Example:
@@ -81,6 +81,7 @@ static struct clock_event_device __percpu *arch_timer_evt;
static enum ppi_nr arch_timer_uses_ppi = VIRT_PPI;
static bool arch_timer_c3stop;
static bool arch_timer_mem_use_virtual;
+static bool arch_counter_suspend_stop;
static bool evtstrm_enable = IS_ENABLED(CONFIG_ARM_ARCH_TIMER_EVTSTREAM);
@@ -576,7 +577,7 @@ static struct clocksource clocksource_counter = {
.rating = 400,
.read = arch_counter_read,
.mask = CLOCKSOURCE_MASK(56),
- .flags = CLOCK_SOURCE_IS_CONTINUOUS | CLOCK_SOURCE_SUSPEND_NONSTOP,
+ .flags = CLOCK_SOURCE_IS_CONTINUOUS,
};
static struct cyclecounter cyclecounter = {
@@ -616,6 +617,8 @@ static void __init arch_counter_register(unsigned type)
arch_timer_read_counter = arch_counter_get_cntvct_mem;
}
+ if (!arch_counter_suspend_stop)
+ clocksource_counter.flags |= CLOCK_SOURCE_SUSPEND_NONSTOP;
start_count = arch_timer_read_counter();
clocksource_register_hz(&clocksource_counter, arch_timer_rate);
cyclecounter.mult = clocksource_counter.mult;
@@ -907,6 +910,10 @@ static int __init arch_timer_of_init(struct device_node *np)
of_property_read_bool(np, "arm,cpu-registers-not-fw-configured"))
arch_timer_uses_ppi = PHYS_SECURE_PPI;
+ /* On some systems, the counter stops ticking when in suspend. */
+ arch_counter_suspend_stop = of_property_read_bool(np,
+ "arm,no-tick-in-suspend");
+
return arch_timer_init();
}
CLOCKSOURCE_OF_DECLARE(armv7_arch_timer, "arm,armv7-timer", arch_timer_of_init);