diff mbox series

usb: chipidea: udc: disconnect/reconnect from host when do suspend/resume

Message ID 20250614124914.207540-1-xu.yang_2@nxp.com
State New
Headers show
Series usb: chipidea: udc: disconnect/reconnect from host when do suspend/resume | expand

Commit Message

Xu Yang June 14, 2025, 12:49 p.m. UTC 
Shawn and John reported a hang issue during system suspend as below:

 - USB gadget is enabled as Ethernet
 - There is data transfer over USB Ethernet (scp a big file between host
                                             and device)
 - Device is going in/out suspend (echo mem > /sys/power/state)

The root cause is the USB device controller is suspended but the USB bus
is still active which caused the USB host continues to transfer data with
device and the device continues to queue USB requests (in this case, a
delayed TCP ACK packet trigger the issue) after controller is suspended,
however the USB controller clock is already gated off. Then if udc driver
access registers after that point, the system will hang.

The correct way to avoid such issue is to disconnect device from host when
the USB bus is not at suspend state. Then the host will receive disconnect
event and stop data transfer in time. To continue make USB gadget device
work after system resume, this will reconnect device automatically.

To make usb wakeup work if USB bus is already at suspend state, this will
keep connection for it only when USB device controller has enabled wakeup
capability.

Reported-by: Shawn Guo <shawnguo@kernel.org>
Reported-by: John Ernberg <john.ernberg@actia.se>
Closes: https://lore.kernel.org/linux-usb/aEZxmlHmjeWcXiF3@dragon/
Tested-by: John Ernberg <john.ernberg@actia.se> # iMX8QXP
Fixes: 235ffc17d014 ("usb: chipidea: udc: add suspend/resume support for device controller")
Cc: stable@vger.kernel.org
Reviewed-by: Jun Li <jun.li@nxp.com>
Signed-off-by: Xu Yang <xu.yang_2@nxp.com>
---
 drivers/usb/chipidea/udc.c | 7 +++++++
 1 file changed, 7 insertions(+)
diff mbox series

Patch

diff --git a/drivers/usb/chipidea/udc.c b/drivers/usb/chipidea/udc.c
index 8a9b31fd5c89..1a48e6440e6c 100644
--- a/drivers/usb/chipidea/udc.c
+++ b/drivers/usb/chipidea/udc.c
@@ -2374,6 +2374,10 @@  static void udc_suspend(struct ci_hdrc *ci)
 	 */
 	if (hw_read(ci, OP_ENDPTLISTADDR, ~0) == 0)
 		hw_write(ci, OP_ENDPTLISTADDR, ~0, ~0);
+
+	if (ci->gadget.connected &&
+	    (!ci->suspended || !device_may_wakeup(ci->dev)))
+		usb_gadget_disconnect(&ci->gadget);
 }
 
 static void udc_resume(struct ci_hdrc *ci, bool power_lost)
@@ -2384,6 +2388,9 @@  static void udc_resume(struct ci_hdrc *ci, bool power_lost)
 					OTGSC_BSVIS | OTGSC_BSVIE);
 		if (ci->vbus_active)
 			usb_gadget_vbus_disconnect(&ci->gadget);
+	} else if (ci->vbus_active && ci->driver &&
+		   !ci->gadget.connected) {
+		usb_gadget_connect(&ci->gadget);
 	}
 
 	/* Restore value 0 if it was set for power lost check */