@@ -559,6 +559,9 @@ static int denali_pio_read(struct denali_nand_info *denali, void *buf,
if (!(irq_status & INTR__PAGE_XFER_INC))
return -EIO;
+ if (irq_status & INTR__ERASED_PAGE)
+ memset(buf, 0xff, size);
+
return irq_status & ecc_err_mask ? -EBADMSG : 0;
}
@@ -631,6 +634,9 @@ static int denali_dma_xfer(struct denali_nand_info *denali, void *buf,
denali_enable_dma(denali, false);
dma_sync_single_for_cpu(denali->dev, dma_addr, size, dir);
+ if (irq_status & INTR__ERASED_PAGE)
+ memset(buf, 0xff, size);
+
return ret;
}
@@ -1423,7 +1429,9 @@ int denali_init(struct denali_nand_info *denali)
chip->ecc.bytes = denali_calc_ecc_bytes(chip->ecc.size,
chip->ecc.strength);
- iowrite32(chip->ecc.strength, denali->flash_reg + ECC_CORRECTION);
+ iowrite32(MAKE_ECC_CORRECTION(chip->ecc.strength,
+ chip->ecc.strength + 1),
+ denali->flash_reg + ECC_CORRECTION);
iowrite32(mtd->erasesize / mtd->writesize,
denali->flash_reg + PAGES_PER_BLOCK);
iowrite32(denali->nand.options & NAND_BUSWIDTH_16 ? 1 : 0,
@@ -109,6 +109,10 @@
#define ECC_CORRECTION 0x1b0
#define ECC_CORRECTION__VALUE GENMASK(4, 0)
+#define ECC_CORRECTION__ERASE_THRESHOLD GENMASK(31, 16)
+#define MAKE_ECC_CORRECTION(val, thresh) \
+ (((val) & (ECC_CORRECTION__VALUE)) | \
+ (((thresh) << 16) & (ECC_CORRECTION__ERASE_THRESHOLD)))
#define READ_MODE 0x1c0
#define READ_MODE__VALUE GENMASK(3, 0)
@@ -237,6 +241,7 @@
#define INTR__RST_COMP BIT(13)
#define INTR__PIPE_CMD_ERR BIT(14)
#define INTR__PAGE_XFER_INC BIT(15)
+#define INTR__ERASED_PAGE BIT(16)
#define PAGE_CNT(bank) (0x430 + (bank) * 0x50)
#define ERR_PAGE_ADDR(bank) (0x440 + (bank) * 0x50)
Recent versions of this IP support automatic erased page detection. If an erased page is detected on reads, the controller does not set INTR__ECC_UNCOR_ERR, but INTR__ERASED_PAGE. If this feature is supported, the driver can use this information instead of calling nand_check_erased_ecc_chunk(). The detection of erased page is based on the number of zeros in the page; if the number of zeros is less than the value in the field ERASED_THRESHOLD, the page is assumed as erased. Set the ERASED_THRESHOLD to (chip->ecc.strength + 1). This is the worst case where all the bitflips come from the same ECC sector. This field is Reserved for older IP versions, so this commit has no impact on them. One thing worth mentioning is the driver still needs to fill the buffer with 0xff in the case because the ECC correction engine has already manipulated the data in the buffer. Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com> --- Changes in v2: - Newly added drivers/mtd/nand/denali.c | 10 +++++++++- drivers/mtd/nand/denali.h | 5 +++++ 2 files changed, 14 insertions(+), 1 deletion(-) -- 2.7.4 ______________________________________________________ Linux MTD discussion mailing list http://lists.infradead.org/mailman/listinfo/linux-mtd/