@@ -247,23 +247,6 @@ static inline int do_transfer_defer(struct sdw_bus *bus,
return ret;
}
-static int sdw_reset_page(struct sdw_bus *bus, u16 dev_num)
-{
- int retry = bus->prop.err_threshold;
- enum sdw_command_response resp;
- int ret = 0, i;
-
- for (i = 0; i <= retry; i++) {
- resp = bus->ops->reset_page_addr(bus, dev_num);
- ret = find_response_code(resp);
- /* if cmd is ok or ignored return */
- if (ret == 0 || ret == -ENODATA)
- return ret;
- }
-
- return ret;
-}
-
static int sdw_transfer_unlocked(struct sdw_bus *bus, struct sdw_msg *msg)
{
int ret;
@@ -275,9 +258,6 @@ static int sdw_transfer_unlocked(struct sdw_bus *bus, struct sdw_msg *msg)
(msg->flags & SDW_MSG_FLAG_WRITE) ? "write" : "read",
msg->addr, msg->len);
- if (msg->page)
- sdw_reset_page(bus, msg->dev_num);
-
return ret;
}
@@ -352,9 +332,6 @@ int sdw_transfer_defer(struct sdw_bus *bus, struct sdw_msg *msg,
dev_err(bus->dev, "Defer trf on Slave %d failed:%d\n",
msg->dev_num, ret);
- if (msg->page)
- sdw_reset_page(bus, msg->dev_num);
-
return ret;
}
Zeroing the page registers at the end of every paged transaction is just overhead (40% overhead on a 1-register access, 25% on a 4-register transaction). According to the spec the peripheral should only use the values in the page registers if the address is paged, and since the page registers are always overwritten at the start of a paged transaction there will never be a transaction that uses the stale values from a previous paged transaction. For peripherals that need large amounts of data to be transferred, for example firmware or filter coefficients, the overhead of page register zeroing can become quite significant. Signed-off-by: Richard Fitzgerald <rf@opensource.cirrus.com> --- drivers/soundwire/bus.c | 23 ----------------------- 1 file changed, 23 deletions(-)