@@ -247,6 +247,8 @@ extern int amdgpu_sg_display;
extern int amdgpu_user_partt_mode;
+extern int amdgpu_wbrf;
+
#define AMDGPU_VM_MAX_NUM_CTX 4096
#define AMDGPU_SG_THRESHOLD (256*1024*1024)
#define AMDGPU_WAIT_IDLE_TIMEOUT_IN_MS 3000
@@ -195,6 +195,7 @@ int amdgpu_use_xgmi_p2p = 1;
int amdgpu_vcnfw_log;
int amdgpu_sg_display = -1; /* auto */
int amdgpu_user_partt_mode = AMDGPU_AUTO_COMPUTE_PARTITION_MODE;
+int amdgpu_wbrf = -1;
static void amdgpu_drv_delayed_reset_work_handler(struct work_struct *work);
@@ -981,6 +982,22 @@ module_param_named(user_partt_mode, amdgpu_user_partt_mode, uint, 0444);
module_param(enforce_isolation, bool, 0444);
MODULE_PARM_DESC(enforce_isolation, "enforce process isolation between graphics and compute . enforce_isolation = on");
+/**
+ * DOC: wbrf (int)
+ * Enable Wifi RFI interference mitigation feature.
+ * Due to electrical and mechanical constraints there may be likely interference of
+ * relatively high-powered harmonics of the (G-)DDR memory clocks with local radio
+ * module frequency bands used by Wifi 6/6e/7. To mitigate the possible RFI interference,
+ * with this feature enabled, PMFW will use either “shadowed P-State” or “P-State” based
+ * on active list of frequencies in-use (to be avoided) as part of initial setting or
+ * P-state transition. However, there may be potential performance impact with this
+ * feature enabled.
+ * (0 = disabled, 1 = enabled, -1 = auto (default setting, will be enabled if supported))
+ */
+MODULE_PARM_DESC(wbrf,
+ "Enable Wifi RFI interference mitigation (0 = disabled, 1 = enabled, -1 = auto(default)");
+module_param_named(wbrf, amdgpu_wbrf, int, 0444);
+
/* These devices are not supported by amdgpu.
* They are supported by the mach64, r128, radeon drivers
*/
@@ -1228,6 +1228,173 @@ static int smu_get_thermal_temperature_range(struct smu_context *smu)
return ret;
}
+/**
+ * smu_wbrf_handle_exclusion_ranges - consume the wbrf exclusion ranges
+ *
+ * @smu: smu_context pointer
+ *
+ * Retrieve the wbrf exclusion ranges and send them to PMFW for proper handling.
+ * Returns 0 on success, error on failure.
+ */
+static int smu_wbrf_handle_exclusion_ranges(struct smu_context *smu)
+{
+ struct wbrf_ranges_out wbrf_exclusion = {0};
+ struct exclusion_range *wifi_bands = wbrf_exclusion.band_list;
+ struct amdgpu_device *adev = smu->adev;
+ uint64_t start, end;
+ int ret, i, j;
+
+ ret = wbrf_retrieve_exclusions(adev->dev, &wbrf_exclusion);
+ if (ret) {
+ dev_err(adev->dev, "Failed to retrieve exclusion ranges!\n");
+ return ret;
+ }
+
+ /*
+ * The exclusion ranges array we got might be filled with holes and duplicate
+ * entries. For example:
+ * {(2400, 2500), (0, 0), (6882, 6962), (2400, 2500), (0, 0), (6117, 6189), (0, 0)...}
+ * We need to do some sortups to eliminate those holes and duplicate entries.
+ * Expected output: {(2400, 2500), (6117, 6189), (6882, 6962), (0, 0)...}
+ */
+ for (i = 0; i < MAX_NUM_OF_WBRF_RANGES; i++) {
+ start = wifi_bands[i].start;
+ end = wifi_bands[i].end;
+
+ /* get the last valid entry to fill the intermediate hole */
+ if (!start && !end) {
+ for (j = MAX_NUM_OF_WBRF_RANGES - 1; j > i; j--)
+ if (wifi_bands[j].start &&
+ wifi_bands[j].end)
+ break;
+
+ if (j > i) {
+ wifi_bands[i].start = wifi_bands[j].start;
+ wifi_bands[i].end = wifi_bands[j].end;
+ wifi_bands[j].start = 0;
+ wifi_bands[j].end = 0;
+ }
+
+ continue;
+ }
+
+ /* eliminate duplicate entries */
+ for (j = i + 1; j < MAX_NUM_OF_WBRF_RANGES; j++) {
+ if ((wifi_bands[j].start == start) &&
+ (wifi_bands[j].end == end)) {
+ wifi_bands[j].start = 0;
+ wifi_bands[j].end = 0;
+ continue;
+ }
+ }
+ }
+
+ /* Send the sorted wifi_bands to PMFW */
+ ret = smu_set_wbrf_exclusion_ranges(smu, wifi_bands);
+ /* Give it another chance */
+ if (unlikely(ret == -EBUSY)) {
+ mdelay(5);
+ ret = smu_set_wbrf_exclusion_ranges(smu, wifi_bands);
+ }
+
+ return ret;
+}
+
+/**
+ * smu_wbrf_event_handler - handle notify events
+ *
+ * @nb: notifier block
+ * @action: event type
+ * @data: event data
+ *
+ * Calls relevant amdgpu function in response to wbrf event
+ * notification from kernel.
+ */
+static int smu_wbrf_event_handler(struct notifier_block *nb,
+ unsigned long action, void *_arg)
+{
+ struct smu_context *smu = container_of(nb, struct smu_context,
+ wbrf_notifier);
+
+ switch (action) {
+ case WBRF_CHANGED:
+ smu_wbrf_handle_exclusion_ranges(smu);
+ break;
+ default:
+ return NOTIFY_DONE;
+ };
+
+ return NOTIFY_OK;
+}
+
+/**
+ * smu_wbrf_support_check - check wbrf support
+ *
+ * @smu: smu_context pointer
+ *
+ * Verifies the ACPI interface whether wbrf is supported.
+ */
+static void smu_wbrf_support_check(struct smu_context *smu)
+{
+ struct amdgpu_device *adev = smu->adev;
+
+ smu->wbrf_supported = smu_is_asic_wbrf_supported(smu) &&
+ !!amdgpu_wbrf &&
+ wbrf_supported_consumer(adev->dev);
+
+ if (smu->wbrf_supported)
+ dev_info(adev->dev, "RF interference mitigation is supported\n");
+}
+
+/**
+ * smu_wbrf_init - init driver wbrf support
+ *
+ * @smu: smu_context pointer
+ *
+ * Verifies the AMD ACPI interfaces and registers with the wbrf
+ * notifier chain if wbrf feature is supported.
+ * Returns 0 on success, error on failure.
+ */
+static int smu_wbrf_init(struct smu_context *smu)
+{
+ struct amdgpu_device *adev = smu->adev;
+ int ret;
+
+ if (!smu->wbrf_supported)
+ return 0;
+
+ smu->wbrf_notifier.notifier_call = smu_wbrf_event_handler;
+ ret = wbrf_register_notifier(&smu->wbrf_notifier);
+ if (ret)
+ return ret;
+
+ /*
+ * Some wifiband exclusion ranges may be already there
+ * before our driver loaded. To make sure our driver
+ * is awared of those exclusion ranges.
+ */
+ ret = smu_wbrf_handle_exclusion_ranges(smu);
+ if (ret)
+ dev_err(adev->dev, "Failed to handle wbrf exclusion ranges\n");
+
+ return ret;
+}
+
+/**
+ * smu_wbrf_fini - tear down driver wbrf support
+ *
+ * @smu: smu_context pointer
+ *
+ * Unregisters with the wbrf notifier chain.
+ */
+static void smu_wbrf_fini(struct smu_context *smu)
+{
+ if (!smu->wbrf_supported)
+ return;
+
+ wbrf_unregister_notifier(&smu->wbrf_notifier);
+}
+
static int smu_smc_hw_setup(struct smu_context *smu)
{
struct smu_feature *feature = &smu->smu_feature;
@@ -1320,6 +1487,15 @@ static int smu_smc_hw_setup(struct smu_context *smu)
if (ret)
return ret;
+ /* Enable UclkShadow on wbrf supported */
+ if (smu->wbrf_supported) {
+ ret = smu_enable_uclk_shadow(smu, true);
+ if (ret) {
+ dev_err(adev->dev, "Failed to enable UclkShadow feature to support wbrf!\n");
+ return ret;
+ }
+ }
+
/*
* With SCPM enabled, these actions(and relevant messages) are
* not needed and permitted.
@@ -1416,6 +1592,15 @@ static int smu_smc_hw_setup(struct smu_context *smu)
*/
ret = smu_set_min_dcef_deep_sleep(smu,
smu->smu_table.boot_values.dcefclk / 100);
+ if (ret) {
+ dev_err(adev->dev, "Error setting min deepsleep dcefclk\n");
+ return ret;
+ }
+
+ /* Init wbrf support. Properly setup the notifier */
+ ret = smu_wbrf_init(smu);
+ if (ret)
+ dev_err(adev->dev, "Error during wbrf init call\n");
return ret;
}
@@ -1471,6 +1656,13 @@ static int smu_hw_init(void *handle)
return ret;
}
+ /*
+ * Check whether wbrf is supported. This needs to be done
+ * before SMU setup starts since part of SMU configuration
+ * relies on this.
+ */
+ smu_wbrf_support_check(smu);
+
if (smu->is_apu) {
ret = smu_set_gfx_imu_enable(smu);
if (ret)
@@ -1623,6 +1815,8 @@ static int smu_smc_hw_cleanup(struct smu_context *smu)
struct amdgpu_device *adev = smu->adev;
int ret = 0;
+ smu_wbrf_fini(smu);
+
cancel_work_sync(&smu->throttling_logging_work);
cancel_work_sync(&smu->interrupt_work);
@@ -22,6 +22,8 @@
#ifndef __AMDGPU_SMU_H__
#define __AMDGPU_SMU_H__
+#include <linux/wbrf.h>
+
#include "amdgpu.h"
#include "kgd_pp_interface.h"
#include "dm_pp_interface.h"
@@ -575,6 +577,10 @@ struct smu_context
u32 debug_resp_reg;
struct delayed_work swctf_delayed_work;
+
+ /* data structures for wbrf feature support */
+ bool wbrf_supported;
+ struct notifier_block wbrf_notifier;
};
struct i2c_adapter;
@@ -1356,6 +1362,23 @@ struct pptable_funcs {
* @init_pptable_microcode: Prepare the pptable microcode to upload via PSP
*/
int (*init_pptable_microcode)(struct smu_context *smu);
+
+ /**
+ * @is_asic_wbrf_supported: check whether PMFW supports the wbrf feature
+ */
+ bool (*is_asic_wbrf_supported)(struct smu_context *smu);
+
+ /**
+ * @enable_uclk_shadow: Enable the uclk shadow feature on wbrf supported
+ */
+ int (*enable_uclk_shadow)(struct smu_context *smu,
+ bool enablement);
+
+ /**
+ * @set_wbrf_exclusion_ranges: notify SMU the wifi bands occupied
+ */
+ int (*set_wbrf_exclusion_ranges)(struct smu_context *smu,
+ struct exclusion_range *exclusion_ranges);
};
typedef enum {
@@ -97,6 +97,9 @@
#define smu_get_default_config_table_settings(smu, config_table) smu_ppt_funcs(get_default_config_table_settings, -EOPNOTSUPP, smu, config_table)
#define smu_set_config_table(smu, config_table) smu_ppt_funcs(set_config_table, -EOPNOTSUPP, smu, config_table)
#define smu_init_pptable_microcode(smu) smu_ppt_funcs(init_pptable_microcode, 0, smu)
+#define smu_is_asic_wbrf_supported(smu) smu_ppt_funcs(is_asic_wbrf_supported, false, smu)
+#define smu_enable_uclk_shadow(smu, enablement) smu_ppt_funcs(enable_uclk_shadow, 0, smu, enablement)
+#define smu_set_wbrf_exclusion_ranges(smu, exclusion_ranges) smu_ppt_funcs(set_wbrf_exclusion_ranges, -EOPNOTSUPP, smu, exclusion_ranges)
#endif
#endif