mbox series

[v3,0/3] Add board support for HK10 board variants

Message ID 1602160344-19586-1-git-send-email-gokulsri@codeaurora.org
Headers show
Series Add board support for HK10 board variants | expand

Message

Gokul Sriram Palanisamy Oct. 8, 2020, 12:32 p.m. UTC 
Added support for HK10-C1 and HK10-C2 board variants based on IPQ8074 SoC.
Both these variants support dual QCN9000 PCIe cards that uses MHI communication
protocol over PCIe. In addition, HK10-C1 support on-chip radio.
Both these variants slightly differ in clock configuation for ethernet.

This series depends on below series:
[V2,0/7] Add PCIe support for IPQ8074
[v7,0/9] remoteproc: qcom: q6v5-wcss: Add support for secure pil

changes since v2:
 - In patch 3, Moved pcie0_rp and pcie1_rp nodes and
   removed unused members and subnodes

Gokul Sriram Palanisamy (3):
  dt-bindings: qcom: Add ipq8074 bindings
  arm64: dts: Add board support for HK10
  arm64: dts: Enabled MHI device over PCIe

 Documentation/devicetree/bindings/arm/qcom.yaml |   4 +
 arch/arm64/boot/dts/qcom/Makefile               |   2 +
 arch/arm64/boot/dts/qcom/ipq8074-hk10-c1.dts    |  11 +++
 arch/arm64/boot/dts/qcom/ipq8074-hk10-c2.dts    |  14 +++
 arch/arm64/boot/dts/qcom/ipq8074-hk10.dtsi      | 123 ++++++++++++++++++++++++
 5 files changed, 154 insertions(+)
 create mode 100644 arch/arm64/boot/dts/qcom/ipq8074-hk10-c1.dts
 create mode 100644 arch/arm64/boot/dts/qcom/ipq8074-hk10-c2.dts
 create mode 100644 arch/arm64/boot/dts/qcom/ipq8074-hk10.dtsi