diff mbox series

[v3,7/8] PCI: qcom: Do not advertise hotplug capability for IP v1.0.0

Message ID 20230601163900.15500-8-manivannan.sadhasivam@linaro.org
State Accepted
Commit 25966e78d3035b6356d9284ad07b3033212c691b
Headers show
Series PCI: qcom: Do not advertise hotplug capability | expand

Commit Message

Manivannan Sadhasivam June 1, 2023, 4:38 p.m. UTC
SoCs making use of Qcom PCIe controller IP v1.0.0 do not support hotplug
functionality. But the hotplug capability bit is set by default in the
hardware. This causes the kernel PCI core to register hotplug service for
the controller and send hotplug commands to it. But those commands will
timeout generating messages as below during boot and suspend/resume.

[    5.782159] pcieport 0001:00:00.0: pciehp: Timeout on hotplug command 0x03c0 (issued 2020 msec ago)
[    5.810161] pcieport 0001:00:00.0: pciehp: Timeout on hotplug command 0x03c0 (issued 2048 msec ago)
[    7.838162] pcieport 0001:00:00.0: pciehp: Timeout on hotplug command 0x07c0 (issued 2020 msec ago)
[    7.870159] pcieport 0001:00:00.0: pciehp: Timeout on hotplug command 0x07c0 (issued 2052 msec ago)

This not only spams the console output but also induces a delay of a
couple of seconds. To fix this issue, let's clear the HPC bit in
PCI_EXP_SLTCAP register as a part of the post init sequence to not
advertise the hotplug capability for the controller.

Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
---
 drivers/pci/controller/dwc/pcie-qcom.c | 2 ++
 1 file changed, 2 insertions(+)
diff mbox series

Patch

diff --git a/drivers/pci/controller/dwc/pcie-qcom.c b/drivers/pci/controller/dwc/pcie-qcom.c
index e6db9e551752..612266fb849a 100644
--- a/drivers/pci/controller/dwc/pcie-qcom.c
+++ b/drivers/pci/controller/dwc/pcie-qcom.c
@@ -521,6 +521,8 @@  static int qcom_pcie_post_init_1_0_0(struct qcom_pcie *pcie)
 		writel(val, pcie->parf + PARF_AXI_MSTR_WR_ADDR_HALT);
 	}
 
+	qcom_pcie_clear_hpc(pcie->pci);
+
 	return 0;
 }